Balanced Phono Connections


I recently got an Audio Research PH2 which uses balanced only connections. This didn't seem a problem to me since I was under the impression that phono cartridges were naturally balanced devices. What I want to do is hook up my Linn Ittok (with Glider) to the PH2. The Linn uses a five pin DIN connector at the base of the arm and RCA connectors for connection to the phono preamp. My first thought was to just get some XLR to RCA adapters as a temporary measure, but when I discussed this with my local Audio Research dealer he said it would not work. I would have a very high noise level and/or lose some of the signal (i.e., one half of the balanced output). This sort of made sense but since all phono cartridges have the same outputs I had difficulty understanding how you could ever get it right then. Despite the dealers concerns I managed to borrow a set of XLR to RCA adapters and the PH2 sounds wonderful! While I could leave it at that, I think there is more to learn here, i.e., even better sound with a better connection. While I could buy a dedicated interconnect (e.g., Kimber TAK) for this I am not sure how long before the analong upgrade bug hits and move on to another arm/table combination. My question is has anyone made their own phono interconnect for balanced? My understanding is the cartridge outputs are the plus and minus, all I have to add to make the cable balanced is the ground reference. Would the ground have to be earth or could it be the turntable chassis (VPI HW-19) and/or the PH2 ground post. I thought this would be simple but I'm doubting myself, please help!
pmotz
To be balanced you would hook it up like you described.

Cartridge + output to the non-inverted pin, the +.
Cartridge - output to the inverted, the -.

You might not have to use the ground pin, but if you do it should usually be hooked to the shielding on the cable. The proper place to connect the ground depends on the setup. Some will hum with no connection and some will not. I've had phono stages where I had to ground the spindle to stop the hum and some it made no difference. You will have to experiment with that.

Your dealer is correct in the sense that what you are doing now is probably not balanced. The adapters you have probably connect the + output of the cartridge to the balanced + and the - output of the cartridge to ground. That will work but it is not balanced.

You can get your own connectors, cut off the RCA connectors and wire it yourself. It is hard to do though because the wires are extremely small and very difficult to work with.
Yes, I have a BAT VKP10SE that has balanced inputs and outputs. I used a DIN to RCA cable for awhile, Then tried a Din to XLR. Noise levels reduced, gain higher, detail, detail, detail. If you have the capability, try a Din to xlr cable.
Hello,
I had exactly your setup a few years ago. Was first using the ARC DIN-to-XLR to the PH2 and then tried the same connections with a SilverBreeze cable from SilverAudio. This latter cable was absolutely phenomenol in terms of clarity and resolution. I was so amazed at how much loss had been occuring with the Audio Research cable for many years. Check out www.silveraudio.com
John
Thanks for the recommendations. The Silver Breeze sounds nice but since I don't know how long I will keep the Ittok I probably won't invest that much into it. I'll probably take Herman's advice and modify what I've already got.