Cartridges for rear of stage orchestral resolution


Any recommendations for moving coils that provide excellent illumination/detail of instruments in the back rows of the symphony orchestra while preserving a weighty, powerful sound ?
opus88
Opus88,
Your current cart may be doing more than you think. What are you using for a phono stage? Even with a 5K$$ cart, using a so-so phono stage will limit your resolution capabilities.

May also suggest you offer what pre amp you are using.

best J
Rsrex and Johnss: I'm currently using a Benz L2 cartridge, SME IV.Vi tonearm, VPI HW-19 Mk III table with specially made brass/aluminum tonearm board. EAR 88PB phono preamp is run directly to Air Tight ATM-3 monoblocks (with Tesla E34Ls, Ei Yugo 12ax7s and Mullard 12au7 "box plates"). Speakers are Dunlavy SC4s. I've adjusted the Dunlavys several times, and have the soundstaging/imaging where I want it. Interconnects: Ridge Street Poiema 3 and Synergistic Tesla Accelerator; phono cable is Audio Horizons Dimension; speaker cables AH Dimension and original Siltech LS-88 Classic bi-wired; power cords are Poiema Ridge Street Signature and Wegrzyn Copper Slam.
Opus88
Rsrex is correct in that back of hall imaging is usually a function of the speakers and room acoustics. Although of course if this information was not in the original signal, it would not be possible to reproduce it.

The other area which you need to look into, and perhaps should do first before investing in another component, is to make sure that the TT, phono/pre, power and speakers are rigidly supported. Also that your cables are elevated/isolated from ground borne vibrations.
Cmk: I've known these speakers to have reproduced very good back of hall imaging before. All of my components do have rigid support, with cables also being isolated and elevated. I feel confident a different cartridge will do the trick. I do thank very much for your desire to help.