2. speakers
  3. 143177-20038

Do $2k speakers + DSP = $50k speakers?

Now that I have your attention, I’d like to share one of my recent experiments. Like many of you, I've never truly been satisfied with my system and often consider purchasing higher-end speakers. I have a variety of speakers in my house including small, high-quality monitors, and mid/high level floor standers and a few subs (all names left intentionally blank) from $2k to $15k. One part of me enjoys the flexibility of monitors while the other part prefers the full-range sound of floor standers. I have a mid-sized room with some strategically placed panels, but the room is average at best.

As a fun project, I used Dirac room correction and bass management, via a MiniDSP unit, to tweak the frequency response of my floor standers. I then used Room EQ Wizard to further tune the frequency response and properly integrate my subs. They sound “good” (and far better than they did without the EQ), but I suspect they’re ultimately limited by the room. I then used this result as a baseline to see how far I could go with my monitors (1/10 the price of the floor standers). I set up my monitors in nearly the same position and went through the same process. I worked to bring the response as close as I could to the floor-stander baseline as possible. I did not fully invest the time to seamlessly integrate the subs, but I must admit I was pretty shocked as to how close I got things when I A-B'ed them.

There are so many speaker manufactures out there with unique strengths and focuses. If you select a speaker with good quality drivers, a solid cabinet, low distortion, good off-axis response, and solid engineering behind it, is the only hurdle left frequency response differences? Can a $2k speaker (with subs and DSP) = a $50k speaker? Thoughts?

hifiguy5

Showing 2 responses by shadorne

shadorne's avatar
Ag insider logo xs@2x
shadorne
7,333 posts
 
The Kii’s use inexpensive drivers according to diyAudio (Peerless $20 x 4, Dayton $16 and Seas $74) but do rely on sophisticated DSP techniques

This is typical even for 10K speakers. A 2K speaker may have even less expensive drivers. That the Kiis with these drivers and DSP came close to B&W 802 D3S does not reflect well on B&W. B&W tend to use small 1 1/4 inch diameter long voice coils similar to the Kiis even if their cone materials are more advanced.

So the answer really depends on driver quality rather than price.

Exceptional drivers with large diameter short voice coil operating in a large gap with extreme tight tolerances will easily outperform cheap drivers with DSP. These kind of drivers cost at least $200 each for a low cost version but can be as much as $1K -$2K each.

So if the 50K speaker has drivers that are commensurate with that price (rather than just expensive cosmetics - veneers can be exceedingly expensive), then the drivers alone could cost double the price of the entire 2K speaker and will outperform in power/dynamics/precision much in the same way an Audi R8 will destroy a Toyota Camry.

shadorne's avatar
Ag insider logo xs@2x
shadorne
7,333 posts
 
@johnk

+1 but fancy cables, re-clockers, mats, power cords, fancy fuses etc, are ALL BANDAIDS. If one has to resort to bandaids then it means the components are inadequate to begin with.
More to discover