According to web page you provided, "The edge of the beveled disc should be 0.2 mm." Since the edge of an unbeveled discs is around 1 to 1.3 mm, that 0.2 mm thickness is only about 1/5 to 1/6 of the original thickness. Probably best to leave a very slight edge so as not to cut oneself on the edge while handling and help prevent chipping.
So, half is not enough according to manufacurer. Edge should be beveled about 80-85% of the way through
The scattering occurs below the surface and when laser hits the edges of the pits and lands....
So, half is not enough according to manufacurer. Edge should be beveled about 80-85% of the way through
The scattering occurs below the surface and when laser hits the edges of the pits and lands....