2. speakers
  3. 1060662631

Echobusters "to gap from wall' or not

I found 6 echobuster panels here on audiogon ( 2' by 4' by 2")and want to hang them mostly on my backwall behind the couch.

The room is 15.5' (widest) by 27' (couch in nook, closets on end make it 12.5 in narrowest area.

Near field setup with back of couch against wall (early cancelations too short delay to notice?)

anyway I have a small amount of echo to tame and was wondering if I should gap the panels from the wall with little wood blocks (2") to achieve slightly lower freq absorbtion and even filtering "from the back side"

does anyone have any suggestions on this?
128x128Ag insider logo xs@2xaudiotomb

Showing 2 responses by octopus

octopus
52 posts
 
I've done it. It makes a noticable difference in the effectiveness of the panels. I cut 1/2" x 1" standoffs and screwed them into all four corners of the panel in back. Then I bought a sheet of those small rubber peel-off circles for furniture and put one over the screw heads so it would not scratch the wall. Go for it.

I've also found that home-built panels just don't sound as good as Echobuster products, even if I try to get the same wood and foam. Something about that wool fabric maybe?
octopus
52 posts
 
The panels are very light. As I recall, I did not use any sort of high-tech hanging scheme. I nailed toothed picture hanging strips to the top middle in the back and used a long nail. For the ceiling I did not use standoffs and just screwed the panels right into the drywall. For an audiophile obsessive, those panels are heaven. I moved mine around so much that the room looked like I held the World Dart Throwing Championship. You are welcome to email me if you have specific questions.
More to discover