HELP AFTER MY MODS, My tweeters are subdued and weak-


So I have a pair of Mirage M1 speakers, I changed the caps in the crossovers to Jantzen Superior Z (for the tweeters) and standard z for the mids and bass.
 
I also changed the internal cabling to Supra Classic 2.5.

First Impressions-  Not burned in yet
The highs are there but really recessed in the background. Theres a song I reference and it has a steel guitar solo, I can bearly hear it through the vocals because its seems recessed so far back.

SO HERES THE QUESTION- Is that a symptom of unburned in cables and or caps, or is that just what Supra cables give you?

When I changed the internal cabling a few years back on the same model speaker, I used DH LABS t14 Silver plated cable, This had the opposite effect, it was super bright and fast, but it smoothed out and the brightness relaxed, leaving a lot of detail but not so much your ears bled.

But here its the opposite, its dull on the top end and the vocals kind of take over and blur out the top end.

idahifi
Another way to go is with bi-polar electrolytics. All caps in parallel add, but in series they divide. Using 2 x 2,200 uF caps in series is the equivalent of a single 1,100uF.

I couldn't find a single bi-polar electrolytic at Parts Express, so I suggest a pair of these:

https://www.parts-express.com/cat/non-polarized-electrolytic-capacitors/1385?N=19844+4294967118+4294...

plus one of these:

https://www.parts-express.com/cat/non-polarized-electrolytic-capacitors/1385?N=19844+4294967118+4294...

Put them in parallel instead of in series. Again, you’ll need to compare the final ESR of the 3 parallel caps to the original serial. I suspect you’ll end up with a much lower ESR and need to adjust.  My guess is your original serial was around 2-6 Ohms of ESR. With 3 parallel, modern bi-polar caps, you'll end up with around half.




Best,

E
So the caps the caps I replaced in c1,c3,c4, were bi polar electrolytics, they say bipolar on the cap. Not sure if that matters or if I mentioned it. 
Btw, all cap in the crossover should be bipolar/non-polarized, therefore the two 2200uf connected back to back.
The negative stripes face each other on the 2200uF's, I'm thinking that's in line with what your saying