2. cables
  3. 1251898166

How do I remove the female plug from Isoclean PC?

I have an Isoclean Super Focus power cord that I need to remove the female plug so that I can hard wire it to a Porter Port recepticle.

The plug has a covering with no screws visible, and I can not figure out how to remove this covering.

I've emailed Isoclean and asked for instructions on how to do this, but have not heard back from them.

You can see how the plugs have a covering over the plug and the screws in this picture: http://www.isocleanpower.com/review/review1-5.htm

Any help would be deeply appreciated.

Thanks,
Chuck
krell_man

Showing 2 responses by jea48

jea48
2,944 posts
 
I believe you mean the male plug.....

Note the white end of the plug see the two small black areas in the picture. This is were the screws are that hold the two pieces of the plug together. One opposite the other.

Isoclean may have filled the holes with some type of resin material.

Curiosity killed the cat.... How are you planing to hard wire the cable to the receptacle? What do you think it will accomplish?
Jim
jea48
2,944 posts
 
Chuck,

OK, I understand now what you want to do.

Did you check the end for screws?

You may have to cut the shrink tube off the female connector and look for the fasteners.

Make sure you get the polarity correct when you connect the cable to the receptacle. Wide blade on the plug is the neutral... Check the continuity of the wire to the plug blade. Wire colours inside the cord may not be black and white.

T slot on the recept is the neutral.
More to discover