Don’t forget to prepare the mating surface of the binding post before soldering by lightly sanding or wire-brushing. This, as well as a modest amount of rosin flux (never use acid flux) will ensure the solder “wets” correctly. This provides as close to a molecular bond as possible. And yes, wrap the wire firmly around the post, or double fold it over if inserting in a tube before soldering. This will give you the required mechanical integrity that is necessary for long term reliability. A good soldering iron or station with the correct (1/8” or larger) tip should be sufficient to heat the post and wire. My preference is the Weller WTCPS or WESD50.
Need some help soldering Binding posts.
I need to replace my posts on my speakers.I've an excellent soldering station
and will be using cardas solder.
All binding posts have a hole what is its function?
When applying the solder I've noticed I must use more and apply over a greater area,Is this correct?
Is it ok to use flux on the post and cable then solder?
Any advice.
Mike
and will be using cardas solder.
All binding posts have a hole what is its function?
When applying the solder I've noticed I must use more and apply over a greater area,Is this correct?
Is it ok to use flux on the post and cable then solder?
Any advice.
Mike