Power conditioner and high end power cord


I am setting up my first system and need to understand if you have a good power conditioner (EQUI=CORE 1800) do you still need these high end AC power cables. The cable I got with the conditioner 6 feet looks very high end not sure how it's made. I have all my components (two -MC601mono blocks, C2600, MD550, MT10, two JL Audio E112 sub, and JL Audio CR-1) going into the EQUI=CORE 1800. If you switch all the components to a higher end AC cables is the sound any better. Or do you need just a high end power cord from the wall to the conditioner and use the cables to the components that they came with. Any help would be appreciated. 

gbprint6559

Showing 1 response by bo1972

Electricity is the foundation of each system. But worldwide it is still done at a very limited level. These days it becomes more often to use a separate power group. But when we talk to manufacturers it becomes clear how little they do and know about electro-smog, magnetism, and high-frequency noise.

Beside this most conditioners are very limited in the end result. When you would understand how to test a conditioner on all different aspects/properties of sound. It becomes more than clear that most conditioners are not able to reveal all the different aspects/properties of sound. This means that they will create a limitation instead of an improvement.

You can get a superior level out of a power cable when you would use a conditioner what can reveal all the aspects/properties of sound. And when you would have done a lot to limit the influence of electro-smog, magnetism, and high-frequency noise.