I looked at the photos of the Quickie on the 'gon and I don't see how you could screw up the hookup on it. That leaves the PS audio. Do you have it set to MM gain with a 47K ohm load (moving magnet settings)? A low impedance load would make it quiet due to the voltage divider effect.
Quicksilver MC Step Up Help
Just purchased a used on from here at Gon. Setup is Scout with Shelter 501->Quick silver MC Stepup->PSAudio GCPH->Preamp
No output at all, (without the MC sound is normal) Qucksilver comes with the outpur RCA cables pre-attached, I have then hooked up to the phono amp.
Coincidently QuickSilver is in hte process of relocating to California and are closed, Waiting for seller to respond. Any help is appreciated.
regards
-BisP
No output at all, (without the MC sound is normal) Qucksilver comes with the outpur RCA cables pre-attached, I have then hooked up to the phono amp.
Coincidently QuickSilver is in hte process of relocating to California and are closed, Waiting for seller to respond. Any help is appreciated.
regards
-BisP
- ...
- 7 posts total
- 7 posts total