Speaker Cable Bi-Wire Jumper Break-in

Count to 10 and you're good to go!

Thanks !!!

I save some time by sticking my jumpers directly into an electrical socket first.  Just like roasting marshmallows, the key is to get a nice golden crust on them but not allowing them to ignite and get charred. ;-)  Nobody likes a burnt jumper.

(and yes, I'm joking....)

How many marshmallows can you do at a time?

Honestly, a few inches of wire will have ZERO effect on SQ. Look inside your speakers and you will see lots of so-so wire connecting the crossovers and drivers! 

Not if its a Totem .

I’ve always noticed different jumpers sound different. My Dali speakers use excellent internal wire   I had a set of cables made from the same wire 

Not looking to debate jumpers. I’ve made that decision based on experience. Was simply curious if those who experienced speaker cable breakin improvements noticed same with jumpers. 

@jl35 …………………………………………………………

Yes, they do sound better after break in.  In my case, about 50 hours.

Thanks stereo5. How did that compare to breakin time for main speaker cables?

Yup, 50 hours or so, sometimes more, sometimes less, but they do sound differently after a while.
B

Jumpers take 76 hours 15 minutes and 18 seconds or maybe less.

My full length cables took 118 hours 36 seconds. Will that change jumpier time ebm?

No break in required.

To answer your question; yes.

thanks much Lak !!!

People who believe there is no break in hear none because your brain
maintains a stasis as job # 1 .

+1 schubert