SUT for Lyra Clavis Evolve 99

EAR MC-4. Very flexible and built like a tank. The MC-4 has 3 ohm, 6 ohm, 12 ohm and 40 ohm taps. The 3 ohm tap is 30x voltage gain and the 6 ohm tap is 24x. The 40 ohm tap is 10x.

How much gain does your phono stage provide? I run my phono stage in MM mode which provides 37 dB gain. Since net dB increase = 20 x log10(Voltage Gain), the MC-4 at 10x voltage gain is basically adding 20dB - total 57 dB for me. I use a Clearaudio Stradivari which is 0.7mV and 30 ohms.

Using the 3 ohm tap for your Lyra, you would have 29 dB gain and at 0.4mV, the phono stage woud see an voltage of 12.0mV. The 6 ohm tap would be about 27.5 dB and see a voltage of 9.60mV. When I bought my EAR, I did speak with Tim de Paravacini and he felt that you had to approach 14.0 mV to overload a MM portion of a well-made phono stage.

You might find it difficult to ID an SUT that will offer less gain at the low impendance you need to match. Can you make any adjustments to your phono stage?

I am no SUT expert, but that's my two cents.

Good luck.

Alanpiga,

Another factor with SUTs is that the SUT will "step down" the impedance that the cartridge "sees" at the phono stage by a factor of the voltage gain squared.

So, for my set-up, at the 40 ohm tap, the gain is 10x the voltage (0.7mV to 7.0mV). My phono stage presents an impedance to the cartrdige of 47k ohm. With the SUT, the stepped down impedance is: 47k ohm/(10^2) = 470 ohm.

This works fine for my Stradavari, as Strats like between 250 - 500 ohms. However, if it did not, my phono stage allows me to use resistors soldered internally to adjust the impedance. The same calculation would be done on this altered impedance to determine the actual impedance the cartrdige sees:

Altered impedance with resistors/(10^2)

Likely that AirTight permits the same.

There are other SUTs out there that are more cost effective. The issue is the transformer windings, which if done less than perfectly can f****p your sound. Tim P is know to be anal retentative about his transformer windings. I paid for "insurance".

I rarely see used EAR gear on AudioGon - maybe satisfied owners??

Send me an e-mail message if you want to chat offline.