Technics SP-10 Tonearm Pod instead of Plinth/Base


Trawling through the Audiogon forums for information on a suitable Plinth for a Technics SP-10, I came across a post by Raul.
Instead of putting the SP-10 in a plinth, he just put the TT on three feet and then had constructed a separate base that only housed the tonearm. (I haven't seen a pic of this BTW)
Following on from Raul's 'Thinking outside the square' approach, I thought I might be able to buy, or have made, a stand-alone 'pod' or rectangular tonearm plinth that could sit along side the SP-10. Has anyone seen something like this that I could buy 'off-the-shelf'?
The advantage of this is that the tonearm is decoupled from the TT and therefore distanced from any vibrations generated by the TT.
A down side is getting the right geometry for the tonearm in relation to the distance from the spindle; and then keeping the pod in the right spot.
If this is all too hard, I might still go with a plinth. I notice an E-Bay seller in Taiwan is offering a Teak plinth cut for the SP-10. Anyone bought one of those?
All comments welcomed!
dsa
Dear Dsa: I try and I have two heavy ( 40-50 kg ) lovely Marble ( green. ) and Onyx ( beige. ) plinths that I used with my Denon's ( DP-80/75. ).

Looks great but I can't say in this precise moment how good against my no plinth approach.

Regards and enjoy the music,
Raul.
I don't have any idea why it might be so, but I have had negative reports on marble as a material for plinths. You can say it rings when you tap it, as does granite, but I have never understood how/why that should be the determining factor. I would stick with slate or wood. The Japanese have virtually no access to slate, which is why some of them may use marble, but I must say also that I have never seen a marble plinth in any of my several trips to Japan, during which I haunt audio stores.
OK, I'm going out-of-the-square.
What about a thick slab of concrete with holes cut-out for the SP-10 and a tonearm? Terrazo? Other aggregates? Does anyone know the sonic properties of the afore mentioned options?
What about three of four cement tiles, with holes cut, and then bonded together?
Concrete might be excellent. I recently saw a Kenwood L07D. It's plinth is made in part of a very dense particulate material, much like concrete. (The plinth is further damped by metal and wood layers.) By all accounts, the L07D is VERY quiet, so I assume the plinth "works". But this makes shipping of an L07D a nightmare, because that concrete-like stuff may crumble if it receives a blunt force blow. I would think also it might be difficult to make a precision fit with concrete, because does it not shrink while drying? But in principle, concrete would be an interesting choice and would probably work well. I see that you propose to start with pre-formed slabs of concrete. Can it be "worked" to accept the SP10 without crumbling? Anyway, it's a cheap experiment.
Hi Lewm,
That is interesting info on the L07D. As for my budget concrete plinth- I suppose I would have to make sure that the 'slab' I buy is able to be cut without crumbling. I regularly see workmen cutting driveways and the like with a water protected circular saw arrangement. The tonearm hole would be easy, the space for the SP10 could be tricky.
What about a material like they use in kitchen benchtops? Nice colours too!