2. analog
  3. 136575-9158

TTW Parts

If you read my other post I wanted advice about vintage Thorens TT.The  reason being I'm having a difficult time finding parts for my TTW Table. I was able to get the rubber O-Rings for the rim drive but suspect they are too hard. I am getting vibration from the attached motor and could hear it. Does anyone know where I can find the proper O-Rings and Belts for the table. I have a good amount of money invested in the table but cant tolerate background noise.
cjaronica
invictus005
597 posts
 
And remember, there will always be noise with rim drive turntables. 
ronnierocksrecords
26 posts
 

When you say noise, what is meant  by that ? there is no noise with my  rim drive

Ron

davejtinney
3 posts
 
I have a TTW GEM Ultra table and found some O-rings on amazon.ca that I have just started to use.
014 Buna-N O-Ring, 70A Durometer, Black, 1/2" ID, 5/8" OD, 1/16" Width (Pack of 100)
It makes no noise and I am using it to see how durable it is.
I tried a red silicone one but it did produce a low hum so I went back to the rubber one.
$7.36 for 100 of them is cheap.

cjaronica OP
109 posts
 
Thanks I will try to find them. I also have the duel belt drive that I am
 using now. Very quiet but a pain to get on.

cjaronica OP
109 posts
 
I Just ordered the Buna O-Rings will let you know how they worked out. Thanks
More to discover