2. amps-preamps
  3. 127327-23130

Tube Power Amp Suggestions

I have been looking for a tube power amp. Ideally I want to have about 40 to 70 watts output power, with sound qualities as close to a delicate SET amp as possible, with lots of details, fast, good tone (a tiny bit on the warm side) and imaging, yet with good bass and dynamic. Budget is about 10,000. Second-hand is fine. I know I am asking really too much and will probably get negative response because of this. I just want to get the best within my budget.    
      
My initial considerations are EAR 890 or EAR 861. What do you think?      
    
I heard people saying that push-pull amp can be better than SET if it is implemented well, but push-pull is more difficult to make than a SET amp.    
      
My speakers are measured 91db sensitivity, but it needs power to perform well. I have tried both a SET 300B XLS output at 13W and a push-pull EL34 at about 35W. My impression is as follow:            
      
- SET 300B XLS output at 13W: more delicate and smooth, better resolution and density, lack bass and dynamic       
- Push-pull EL34 at 35W: much more bass and dynamic, sounds a bit coarse, less 3-dimensional and delicate     
    
Thank you in advance for your input. 
   

bigdish

Showing 1 response by niodari

niodari's avatar
niodari
33 posts
 
You don't really need that much tube power to drive 91db speakers.
50 watts in tube give almost double compared to the solid state.  I bought a 50 watts (in push-pull) Manley Stingray about 16 years or so
(the cost then was far below 10k). It drives excellent 86db Thiel 3.6 (with the recommended minimal amp power of 100 watts). I like this combination, the amp is quite good. Though  I can hear more distortion on it (compared to a solid state McIntosh, for instance), the sound is really  sweet  encouraging. It is quite compact and nicely looking. Only one year ago it needed some maintenance.  
More to discover