TW-Acustic Raven 10.5 or DaVinci Grandezza??


Seems like a crazy question!
I am getting a Raven one but will have a choice of the Raven 10.5 or DaVinci Grandezza for just $2000 more! Which should I go for? Well I am not sure if Raven one is a good match to this super arm but the 10.5 have got great reviews. Please give soem advice.
luna
Der,

what' the best/easiest way (tools) to determine (test) for balanced voltage output of the cart coils ?
Rockitman, all you need is an oscillating pad and a µV meter - that's it.
The technical straight way to determine coil output independent from stylus position/mounting position.
This way you get the raw coil response - totally independent of any position of the polished area to a groove.
I am sure that the "usual suspects" here on Audiogon did - of course ... - already knew it......
As always,
D.
Dear DT, Adjusting azimuth is not the best way to deal with channel imbalance that you describe in your example. Azimuth has very little effect on channel balance. Azimuth affects crosstalk, of the L channel signal into the R channel and vice-versa. This is not the same as channel balance. To prove this to myself, I once did the experiment with my Triplanar. Extreme azimuth change, from one side to the other, effected at most a 1db change in channel balance (going from extreme right bias to extreme left bias), and in doing so resulted in azimuth that was entirely unacceptable in any other way. (Stylus way over on its side, so signal was distorted and stylus wear would be an issue, and crosstalk was way off.)
Dear Lewm, I know it is crosstalk - nevertheless, give my proposition a thought and muse about what is the motivation in most set-ups to start "adjusting" azimuth ?
In other words - I for one haven't seen a mispositioned (i.e. anything else than dead 90° vertical) stylus in the last 12 years on ANY new cartridge.
So .... why do we adjust azimuth then ?
Dertonarm, you are stretching miles to defend the undefendable and might end up in the woods. We are not living in a perfect audio world. Azimuth adjustment available on the arm should be a better solution (although not cost effective for 5K arm) in the unfortunate event when needed than using tiny washers between head shell and cartridge (which is very cost effective for 11K arm).

BTW, your preset opinion against the German arm on the Subject is well documented in another discussion even before its availability and the availability of Uni-Pro as well.

http://forum.audiogon.com/cgi-bin/fr.pl?eanlg&1263686265&openfrom&1&4&&st50

Guess what's really count counts, that's why Uni-Pro has a template for the relative new German arm in the subject. My doubts are whether the template provided by Uni-Pro can be trusted.