The creek is the problem and the solution. My buddy did a very similar thing and switched to the creek passive and seperate amp from an integrated amp. The extra resolution made his system sound bright and very hard on the ears. It is not the creeks fault but the cables that sounded fine in the old set up were now way to bright sounding. You need only try switching the interconnects to get the sound you want back and better then ever.
I'm depressed, my system hurts my ears.Please help
I've been enjoying my stereo for quite some time now, but my latest component addition is hurting my ears. My system is as follows:
Music Hall CD25 CD player
McIntosh MC2105 amp (30 year old amp)
Joseph Audio RM22si signatures
Signal Cable Analog 2 interconnects
Kimber 4TC biwired speaker cable
Denon AVR1700 HT receiver as preamp
With the Denon the system sounded pretty good, but it was the obvious weak link, and was actually performing its own unnecessary A to D to A conversion). I swapped the Denon for a Creek OBH12 passive. I added the Creek because in my careful, volume leveled comparisons of the Denon compared to no pre at all, no pre was much cleaner and more natural (I an use no pre because amp has volume knobs).
So I put in the Creek passive to keep that clarity along with switching and an easy volume control, but now I can't sit in the sweet spot of my speakers and listen, because my ears start to hurt at volume levels that used to be just fine. Is this clipping due to an impedance matching problem? Is this just me receiving the full spectrum of the sound and my ears can't handle it? I remember having a similar problem with a very nice car stereo I installed, it sounded very good but always hurt my ears compared to my worse sounding older car stereo.
I almost wish I had never started down the audiophile path, this is depressing. It's tough to do swapping style comparisons because once my ears start hurting, any music will make them hurt until they have a chance to recover. Any suggestions would be most appreciated.
Music Hall CD25 CD player
McIntosh MC2105 amp (30 year old amp)
Joseph Audio RM22si signatures
Signal Cable Analog 2 interconnects
Kimber 4TC biwired speaker cable
Denon AVR1700 HT receiver as preamp
With the Denon the system sounded pretty good, but it was the obvious weak link, and was actually performing its own unnecessary A to D to A conversion). I swapped the Denon for a Creek OBH12 passive. I added the Creek because in my careful, volume leveled comparisons of the Denon compared to no pre at all, no pre was much cleaner and more natural (I an use no pre because amp has volume knobs).
So I put in the Creek passive to keep that clarity along with switching and an easy volume control, but now I can't sit in the sweet spot of my speakers and listen, because my ears start to hurt at volume levels that used to be just fine. Is this clipping due to an impedance matching problem? Is this just me receiving the full spectrum of the sound and my ears can't handle it? I remember having a similar problem with a very nice car stereo I installed, it sounded very good but always hurt my ears compared to my worse sounding older car stereo.
I almost wish I had never started down the audiophile path, this is depressing. It's tough to do swapping style comparisons because once my ears start hurting, any music will make them hurt until they have a chance to recover. Any suggestions would be most appreciated.
- ...
- 29 posts total
- 29 posts total