Tube pre-amps: what defines "better"


Long story short: trusted audiophile friends recommend I add a tube pre-amp to my audio system. As with all gear, pricing is a very large range, so the usual irritating question is on my mind! -- what do I look for in a tube pre-amp that would send me to, say, a $1500 product over a $350 product? Beyond the issues of fit and finish, country of origin (as usual, the Chinese products are relatively lower-priced)...what in your mind makes for a stand-out tube preamp? Thanks for any advice.

J.
jpaik
Like many things in life, the better ones devote more attention to detail - both in their manufacture/design and their sound. I have upgraded my tube preamps from a Quad 22 (say 150 USD now) to a Verdier Control B with valve PSU (2300 GBP 4000 USD) to my current Tron Meteor (6000 GBP 11000 USD - replaced by the New TRON Syren - www.tron-electric.com). The mass of the preamps has increased considerably to reflect the better PSUs. However, more is not always better. It is important to get the details in the design correct - good quality power supplies, top grade or bespoke components. short signal paths which are correctly aligned to minimise noise etc. Inevitably this costs money and time. My Tron Meteor preamp took over 70 hours to build and weighs several times that of the Verdier let alone the Quad.
So what do I hear - very little! It's as if all the grain in the sound has been removed. The sound is transparent without noise. Soundstaging is natural and the Tron makes everything sound more like real music. That's what it's all about.

the rest of my system is
Platine Verdier Schroeder 2 Allaerts MC1B, Quad IIs (GT Audio rebuilt), Avantgarde Duos with PHY-HP cabling
I've been using Conrad Johnson tube preamps since the mid-l980s -- first the Premier 3 and now the Premier 14 -- and when I upgrade it will be to another CJ. Good luck, Dave
The next time you see a used Audio Electronic Supply, AES 3, made by Cary buy it. Usually in the $300 to $400 range. Be sure to replace the Chinese tubes with some better ones such as Sylvanias. It uses two 6SN7s. If you don't like it or decide to buy more expensive, you are likely to get most if not all your money back. I use one in front of a Llano 100 watt solid state driving Hales Rev 3s and am very happy. Other amps and preamps used include Acurus A150 amp and R10 Pre, Classe CAP 151, a Creek passive, and a Sim I5. The current combo just sound more natural. That is I can hear the wood in an accoustic guitar better than with other set ups. Click on the system link for a list of my current set up. Good luck and happy listening.
Many thanks to all of you, who provided such thoughtful responses and advice. I finally have some time to read carefully through what you have written and digest it all!

J.