Are two dedicated lines better than one?


Sorry if this has been discussed before,but next week my electrician is coming to put in a dedicated line.I need to connect my Lamm LL2 preamp,ARC Classic 60 amp,Meridian 588 CD Plyayer,SME Model 10 Turntable and ARC PH1SE. I was going to install one line with 4 outlets but I have 5 components.I do have a Chang conditioner that I can use but would it be better to have a second line put in while the electrician is here? Do 2 lines introduce more noise than a single line? Is it better to seperate components to different lines? I would really appreciate any advice!
aredelico
I did 5 lines in my place,(2 30 amp lines for each Monoblock amp, 1 20mp for Digitial, Analog (turntables, phono Preamp, and 1 for Standard Preamp, at the time i was running huge Fourier Panthere Tube OTLs for amps, A Counterpoint SA11 17 tube preamp, and a Counterpoint SA9 13 tune phono stage) kinda overkill however the extra costs and time were insignificant, so I did it, isnt going over the top one of the characteristics of high end??

Ive since pared down some of gear, but the extra $150 in parts/labor costs I felt were well worth it
Stehno,
Is there any better if I use power conditioners with dedicated lines. If so, which source(s) should be used with the power conditioner primary. Assuming that I have only one power conditioner.
Thanks so lot in advance.
Oanhu, if I understand your first question correctly, the answer is dedicated lines do nothing to clean up dirty AC. With the exception that the digital source will no longer inject it's digital noise into the other components.

Therefore, if a power conditioner had benefit before dedicated lines, one should realize benefits from the power conditioner after dedicated lines.

In my experience, I realized greater benefit installing a line conditioner for the amplifier, then the pre-amp, then the cdp. Other's will disagree with this priority but that's my experience.

-IMO
I have also done the same as several of the other responders. Two lines; one for the front-end, and one for the amp. The cost is minimal, but the impact was worth it! I would not go back to one circuit again. I also recommend 15 amp for the front-end, and 20 amp breaker for the amp.
Go for it!
I have four 20 amp dedicated lines to four dedicated outlets and use every outlet. Ideally it would be nice to have a dedicated line for each piece of gear. Like others above, I agree it's important to keep digital gear separate from other components.

The single most important benefit of dedicated lines is that they prevent "noise, garbage, and grunge" from any other household appliance from interfering w/ your stereo components, and the affect of this is to greatly lower noise floor. So in effect the ded. line really does clean up the AC your stereo components are receiving. Cheers. Craig