What tweak, what to do?


Hi. First time on this forum. I need advice.

The very quick version of my question is: what makes a bigger difference to resolution, bass extention, etc., an decent equipment rack or isolation devices like the vibrapods or tenderfoot?

I have a limited number of $ -- around $200 tops -- to spend to improve my system. I have: Naim Nait 3, Naim Flat cap, Rega Planet, Rega Planar 2 w/super bias (that's got at least 1000 hrs on it), ProAc Sig Tablette 50's with custom stands, Sunfire True Sig Subwoofer Mk2. The flat cap has a crossover that diverts low hz signal to the sub. Odd set up, but, if well positioned, can be fantastic. But it's quite sensitive to set up. The gear is placed on a none to rigid coffee table, with the turntable on a separate side table. All are on carpeted cement floor in basement.

I love vinyl. One obvious thing to do is replace the cartridge with something much better (e.g., Exact, Dynavector 10x5). But I just don't have the $ to do that now.

Another is to get an equipment rack. I can maybe get a used one -- perhaps a Standesign design 4. That will give better isolation to the whole system. (By the way, is it ok to put the t-table on the top shelf with other electronic below? or is it imperative to have a separate support for the 'table?) On the other hand, that would eat up the whole budget, and i wonder if I cant get as much or more benefit from a couple of sets of cheap isolation devices for under the CD player and t-table, and have a few $ left over for other tweaks -- such as herbies t-table mat and grungbuster (comments on these?.

Too many options, not enough $ or information. A chronic problem with a million faces.

Thanks for the input.

Richard M
rnm4
Richard:

Review the following thread for rack ideas. My preference would be for the Ikea "Lack" DIY rack (fairly easy to assemble) which should run under $100 for a 4 shelf version.

It is important to follow the guidelines/instruction (short or no legs on the base/bottom shelf with spikes @ every level).

As the tables are already finished (you have a choice of colors) it can be quite attractive as well (even for those w/o a great deal of woodworking experience).

A cosmetic "tip" is to tape the legs to be cut with masking tape, in order to avoid chipping the finish, and to use use an appropriate fine toothed/finishing saw blade. A finishing hand saw should do fine if you do not have access to power tools.

http://forum.audiogon.com/cgi-bin/fr.pl?htech&1001889380&read&keyw&zzikea+and+lack
A dedicated line would have the biggest bang for the buck and leave you some money for LP purchases.
Thanks all. Much to ponder. I'm no DYIer by nature -- my hanbdy skills are in the kitchen. It's often all i can do to built to ikea stuff itself, let alone modify it. But perhaps I'll try.

Viridian: dedicated line? Explain please. Is that a dedicated elctrical circuit?
Richard,

If you are great in the kitchen then perhaps you could bribe a handyman friend to do some DIY in exchange for a great meal. For sure, if everything is sitting on carpet and not coupled to the concrete floor my first post is correct and a no brainer. Email if you would like photos sent to you for exactly what you need. Find the handyman and I'll send you the inserts and spikes for free. Can't get much cheaper than that!!!! Listen to Viridian too.
SAve your money and buy a good rack. Do not waste your money on isolation devices until you get a good foundation. For your gear I would go light and rigid. Check out Sound Organization or Target. I would also recommend a wall shelf for the TT even if you do not have major footfall problems. Once you get the rack then maybe look to cones, bearings... to manage airborn or internally dources vibration.