Bryston 28bsst2 worthy upgrade from a krell fpb70?

I am using a magnepan mg 20.7, i was wondering if the bryston 28bsst2 is in the same league or better than my older krell fpb700?

That's the question for you to answer.

IMO, I much prefer modern day SS sound. More open, less dark, less grain ... I'm the biggest Krell amp fan but will not waste $$ recapping old Krells.

You should also add Hegel H30 to your list.

Hi Mclsound, I got a good laugh, + 1, I agree entirely with your post.

Audiolabyrinth,

Just curious, what have you modyfied on your Krell? On my side, I got rid of the fixed AC cords and installed a Furutech Rodhium AC inlet and used Shunyata Anaconda CX power cords. Also installled Bybee AC purifiers at the input of the primary of the AC transformers. Got me greater resolution from bass to treble, increase in soundstage and lower noise floor. These mods are effective while keeping the original design unaltered.

Audiolabyrinth,

Just curious, what have you modyfied on your Krell? On my side, I got rid of the fixed AC cords and installed a Furutech Rodhium AC inlet and used Shunyata Anaconda CX power cords. Also installled Bybee AC purifiers at the input of the primary of the AC transformers. Got me greater resolution from bass to treble, increase in soundstage and lower noise floor. These mods are effective while keeping the original design unaltered.

Hi dasign, I had krell do a special job to my amp, every capacitor in the entire amp was replaced by caps that are not oem to this model krell, these caps were not available in 2005, then I also had the power supplies tweaked, I have sent this amp back to krell a few times for further mods, costly!, anyway, funny you have said something about Furutech, LOL!, I have the Furutech GTX-D Rhodium outlet on my digital now, however, I just did a vey long a/b testing with the Gold and Rhodium GTX-D outlet's for the 700cx here, agonizing actually, I must have changed wpo's in the wall between four different wpo's 25 times or more, I am not kidding about that, I am also addresseing the wall plug on the fixed ac cord, I do not know where to get an IEC done on this amp, krell does not have any more back plates for the amp, and they do not do machine work on the back plates for this amp for customers, unless you could help, I am getting the Furutech FI-50 Rhodium wall plug, also, I am putting a 30 amp single pole breaker on my amp as krell specified, krell claim's that the amp will run smoother and have a bigger better sound stage, I do have the 3/1 solid core copper 10 awg Romex I installed myself, so everything is set for the single pole 30 amp breaker, currently, I have a Tara Labs Cobalt with oyaide termination's power cord on my digital with the first GTX-D R is, also, I am putting the synerjistic research REDS fuses in the amp, one of my next moves, krell sent me a hand wrench to take the top plate off, I will have to have four of the directional fuses, large fast blow fuses, exspensive here too, $400.00 for the 4 of them, as you can see, I am still building here, the bulk of the modds have been done, but I am further tricking this amp out, any advice is welcome, thankyou for you reply, Happy new year.