Good passive subwoofer?


I have an unused Adcom GFA-555 amplifier rated at 600 watts bridged mono into 8 ohms. I am thinking about using it to power a passive sub. Does that sound like a good idea? It would be mostly for use with movies, as I am happy with the full-range bass in my KEF 104.2's for 2 channel music. Any suggestions for a passive sub? The signal path would be from the sub pre-out on my pre/pro or receiver (which I haven't chosen yet). Thanks!
javachip
Audio Control Richter Scale III has a bass eq, crossover and microphone (I use this in my HT on my Velodyne and used it on my VMPS)

Or http://www.behringer.com/DSP8024/index.cfm?lang=ENG

Or Tact system (which is awesome by the way but way more money)

On bridging the amp, get a VMPS larger and you can use a channel on each driver! but that sub is huge! (15" and 18" plus a passive radiator)
Thanks to all for the very helpful info. I looked at the VMPS website; it appears not to have been updated since 2002. Their phone number still works, so I left a message.
I will check out the other suggested brands as well.

How important is the phase control? What changes do you hear as you adjust from 0 to 180 (or whatever), and how noticeable are those changes? Can the same changes be achieved by adjusting sub placement?
Oh, another question. Is phase control more important with one sub or two subs, or is it equally important with both?
http://www.audiocircle.com/circles/viewforum.php?f=39&sid=07cac4d51643f2e4f8299ffef0ca7298

This is the VMPS forum, and there are two dealers here that hang out and can provide discounts. The European website is better, as the US one is pretty static.

http://www.vmpseurope.com/

Yes Phase control is important for both speaker for matching with your main speakers. I haven't had to use it as I've been pretty lucky but both subs would need that adjustment and is included on almost all crossovers.
Phase shifts can make a big difference. Without a sub crosover you can shift phase 180 degrees by inverting the polarity at the speaker or amp. Speaker placement is still the most important consideration though.

If your room is symetrical and you can place the subs symetricaly in the room (and still move them about for optimal performance) then stereo subs is the way to go. Most sub controlers are going to shift phase and change levels equaly to both subs.

If your room is not symetrical (or you can't place them symetricaly) you will be better off with one sub placed properly. Plus one sub is about ten times easier to set-up than two.

Good powered subwoofers are easy to set up and sound very good. It helps tremendously to have a patient helper to adjust the controls for you while you sit in the sweet spot.

Good luck!