Single vs Dual Subs


Let's assume the budget is around $2k.

On the one hand, you could pick up a used/demo JL Audio or Velodyne DD-series. On the other, you could get a pair of new subs from Hsu Research or SVS. Given that the solution has to work well for 2-channel music as well as 5-channel movies, what would sway one in one direction or the other?

Thanks,
Lou
lhf63
Post removed 
Somec59 said:
Dual element push-pull subs are smaller in size than single element subs
OK. Manufacturers?

Bob said:
For movies the LFE is a discrete channel, so why not take advantage of it?

Sure, the LFE is there. The question would be, "Since the LFE is mono, might one getter better 2-channel performance by keeping the L and R signals distinct?" The idea would be, to me, that the subs are just making the mains more full-range, while the LFE is combining all the LF into a single channel.

I do appreciate all the thoughts here. It's helping me think through my approach to this.

Lou
Lou,

I recently spent about 6 or 7 months researching subs; listening when I could and studying test results as well. My quick take:

1) Audyssey, SVS/Audyssey, Velodyne SMS allow parametric EQ below the x-over frequency. The benefit in seamless integration and smooth deep bass (i.e. "fixing your room")is amazing. If your pre/pre-pro/receiver doesn't have this feature, I'd budget $450 (Velo SMS) to $800 (SVS/Audyssey) to add it.

2) 2 subs have many benefits - at your budget, I'd definitely go that way.

3) I spent a LOT of time with the JLs. They are great subs, but expensive. The Hsu product looks good, but the SVS subs appear to be superior all around performers for similar $ (caveat: based on test results here -not listening sessions). I did a lot of research and picked the Rythmik subs (which are very satisfying in my music only system), but if I wanted dual use - music AND ht - I'd probably go with the SVS.

Good Luck,

Marty
BTW,

I suspect that any of the 12" models from Rythmik, SVS, or Hsu will be satisfying. The Rythmiks don't test as well below 35hz (as a practical matter, this is strictly HT territory), but they allow variable damping that's proven quite useful in system matching/fine tuning. In actual use, my pair of 12" subs reproduce 25hz test tones at high spl without breaking a sweat. They'd also go well below that if I adjusted the EQ and susonic filter to allow it.

As far as the LFE goes - try it both ways. Depending on your room and the main speakers in use (with the attendant selection of the best x-over point) it may, or may not, make a difference.

Marty
Didn't this issue come up in a series of posts a short while ago? One of the posters cited the Harmon web site. Their expert advice based on psychoacoustic research differs from that given in these posts. Given that LF has little or no directional information, a high quality sub well placed is usually sufficient except for very large spaces. Well placed is often in a corner. You might Goggle harmon, where you will find a series of technical papers dealing with various aspects of audio, including LF reproduction.

db