2. speakers
  3. 1270066132

Do any amps have 6 ohm taps for 6 ohm impedance?

I'm a newbie, and I don't understand how impedance works. I've just bought a pair of Hyperion 938 speakers that the Hyperion website lists as having a 6 ohms impedance with 3.8 ohms minimum. I'm traveling right now, but I'm pretty sure my amp has 4 ohms taps and 8 ohms taps, maybe even 16 ohms. I'm planning on buying a new solid state amp to drive these speakers, but am I likely to find an amp with 6 ohms taps? Do they exist? And if I don't find one, can I drive these speakers using the 8 ohms taps?

Thanks any help anyone can offer. I know this is a truly ignorant question.

128x128klein_rogge
kijanki's avatar
kijanki
3,575 posts
 
Klein_rogge - 200W is only 22% louder than 100W. I drive Rowland with Benchmark DAC1 without preamp. You will find good class D bargains in Wyred4Sound. I don't know Plinus 9200 but it remember it had great reviews.
rrog
1,958 posts
 
It is my understanding the taps are slightly lower impedance than marked by most manufacturers.

VTL and Manley set theirs at 5 or 5.5 ohms I believe.

It's all a matter of taste. Try both taps and see what you prefer. The 8 ohm tap usually sounds warmer.
face
516 posts
 
McIntosh recommends the 4ohm taps for 6ohm speakers.
magfan
1,583 posts
 
with the minimum being 3.8, I'd go with the 4ohm taps....
johnk's avatar
johnk
1,490 posts
 
You have a 4ohm loudspeaker, min ohm loads is where you should rate impedance. Thus not a 6 ohm but at 3.8ohm a 4 ohm load.
More to discover