Graham Supreme 10 inch mounting

If you have the tool kit for your Graham its very easy to set up, place the nipple on then spindle then align the tonearm so the outer hole in the tonearm fits of the nipple and the tonearm is placed the exacting distance from the spindle - very ingenious I think.

Anyway, have this information from Mr Graham supplied to me for use with my GrooveMaster Vintage Direct Tables

Effective Length:
9" = 235mm
10" = 248mm
12" = 309mm

Spindle to pivot distance:
9" = 217.4mm
10" = 229.4mm
12" = 295.6mm

Good listening

Peter

Thank you so much.
I asked the question because I was not supplied with any protractor for my long arm. Your answer is very complete, much appreciated!

Your Welcome

You actually do not need a protractor for the Graham, the arm it self is the "protractor" Theres two holes drilled in the head shell these are whats used to set the spindle to pivot distance and to mount the cartridge in the head shell once the arm base is mounted to the plinth.

The outer hole is the spindle to pivot distance, and is to be used with the small plastic nipple that placed on the spindle. Both holes together places the arm wand in the exacting position in the mounting fixture supplied with the arm, to align the cartridge in the head shell. Ill post a few pictures on my systems page to better illustrate this. I think its among the most ingenious designs made for setting up tonearm geometry.

Good Listening

Peter

Posted a new System to detail the Graham Setup, Enjoy your new Tonearm

Graham Alignment

Good Listening

Peter