Review: Harman Kardon HK990 Amplifier


Category: Amplifiers

It's really great to have an amp driving the AR9's again that doubles down on power. When the 9's were new, I biamped them with a pair of high current amps which doubled down, but time eventually did what it does to all amplifiers, and since then I've had several pairs of amps which made the 9's sound dull and boring. Once I had 1000w per tower with a pair of high current amps which doubled down and even then the 9's fell flat--not in a good sense. I told myself that time was wearing down the 9's like it did the amps--that the crossovers were getting tired. Or maybe the loss I was experiencing was actually my youthful imagination. Maybe the 9's never were commanding speakers that could talk a throaty, articulate musical language except in my youthful imagination.

Now with the HK990 I have the second amp that doubles down and the first one I don't need two of to drive the 9's, which are so full of sound again that they seem taller than their 4' ll 1/2" towers. They are even overful so that the transcients leap out of them; and they talk again. A friend who goes all the way back with the 9's said, "you'd never guess they aren't biamped". The HK990 is a beast which, inspite of the speakers' demands on this amplifier, runs only very, very warm--not hot.

The HK990 is an atypical integrated amp because the control amplifier is an active gain stage as stated in the owner's manual with its own voltage supply, and this integrated has the robust sound of separates where the preamp is an active gain stage. The preamp and power amp sections are not connected externally with bad-sounding U jumpers that need to be replaced with costly IC's. The switching is internal, and to access the power amp section you simply connect an external preamp to the "processor" input and select said source button on the front panel or remote. All six inputs have an adjustable "gain" feature so that switching from one source to another can be adjusted for consistency in output level. Set at zero gain, the power amp demonstrates only moderate gain. The more the gain in solid state amplification, the more the distortion; and the HK990 has the healthy sound of a power amp with only moderate gain. However, the preamp set at zero gain seems to have too much gain--seems to drive the power amp too hard, although when the HK990 drives higher impedence, less demanding speakers, the negative effects of this higher gain would diminish or maybe disappear. But when I trim the gain as much as possible, the sound quality is superb, and you can play with this feature to find the sweet spot. The gain feature significantly contributes to the amp's agility not only because it can eliminate irritating changes in sound level among various sources but also because it can be used to achieve optimum performance.

The HK990 left my highly regarded preamp and $400 DAC in the dust. I'll just say that's because of RLS 1V (Real-Time Linear Smoothing) because that's the easy, simplistic answer, although I'm sure there are plenty of other reasons, among them being that it's a bit of a hurdle to outperform the current $400 DAC's but surely not one too high for HK. RLS is a device that improves linearity at the point where the digital signal is converted to analogue and normally found only in high end professional equipment. Joe at HCGconsumergroup (Harman Kardon) has informed me that RLS is "not usually found in 'consumer' type products". Compared with my reference preamp and DAC, highs are open and smooth; bass is hard-hitting and thundrous, bass extention could hardly be improved.

Add to it the companion HD990 CD player with HRS Link and you can tweak the sound quality even more. HRS Link is an optional output on the CD player which locks onto the HK990's external clock to illiminate jitter using a cable that is included with the HD990 and that uses a standard RJ45 "network" connector. It is proprietary and is found only on Harman Kardon and Mark Levinson components per Joe. Using a reference digital cable which I connected to one of the HK990's inputs, I compared a digital input signal with and without HRS Link. First impression was that something was missing in the sound with HRS Link. The unconsious mind apparently processes jitter as a part of the music, and with HRS Link there is less quantity of sound so that sound minus jitter equals a purer sound. I found one review which claimed HRS Link to be definitely superior and one which could hear no difference in the several outputs of the HD990. These inconsistencies might be explained by the differences in other components--namely speakers and cable--or the room. Adaquate break-in is of course important as well previous to any critical listening. You will know when the HK990 has turned the corner on break-in. With this amp, break-in is dramatic.

The HK990 pretty much succeeds in being all things to all users. It features optional balanced imputs, optional "Direct Path" which minimizes switching in the analogue inputs, two sets of speaker terminals connected in parallel with a load warning, and a detachable power cord absent the ground termination but which accepts an EIAC power cord. It features optional tone controls, subwoofer outs with bass management, and room equalization as well. It includes an AD converter and phono section with MM and MC inputs. No USB port.

The HK990 does have one quirk that I haven't experienced with any other amp. When an appliance or a light switch is turned on, it cuts out for a split-second. Joe at HK said he's only heard of this issue from me and from his own experience with another model HK amp. His amp exhibited this behavior after he moved from one house to another. He resolved the issue by connecting the amp to another circuit, as I also did. Other possible solutions that come to mind are a dedicated circuit or a power conditioner with a storage capacitor, a feature absent in my entry level power conditioners. But the amp is so good that I would live with this anomaly.

The sound quality of the HK990 puts it deep into high end territory and makes it an extraordinary value. The extraneous components and features all in one box are just the bonus.

Lynne Arnett

CD's: Yellow Jackets, Time Squared; Flim & the BB's, Tricycle Gold; Don Dorsey, Beetovan or Bust; Yes, Fragile (MFSL); Dave Matthews Band, Crash; Norah Jones, Featuring..; Various Artists, Funky Organ; Dire Straits, Dire Straits; Holly Cole Trio, Don't Smoke in Bed; Johnny Cash, The Essential Johnny Cash. Cat Stevens, Cat Stevens Gold.

Associated gear
HD990 CD player
Acoustic Research AR9 (1978-1982)87db
SPL, 400w continuous
Anti-cable by Paul Speltz

Similar products
NAD
Simaudio
arnettpartners
The letter-on-and-off thing in the dot matrix display happened to me sporadically too as it did with Arnettpartners.
To Danoroo (and ArnettPartners): I have been a longtime lurker on these forums and never posted until now. I thought I was going to be the only one who had ever had this anomaly (since the HK 990 seems to be somewhat rare). You're two posts confirm my suspicion on what was causing this scary phenomena.

I had the error with the volume happen 3 times, and I finally narrowed it down and can probably reproduce it (not that I would want to). I guess since it is a real issue I will call it the HK 990 runaway volume issue. If you can point me to the european forum that describes this, please do as I have not ever seen this pop up before publicly.

Let me explain how this happened to me:
In my normal listening setup, I primarily listen to a Dual 721 TT connected to the HK 990 via the MM inputs and ground wire connected there too. I also have a media comp. connected via toslink-1 and cable box connected via toslink-2. I have used the amp with no issues, only immense satisfaction at how awesome it sounds connected to these devices and outputting to KEF LS50 speakers and Klipsch 12 sub. Amazing sound. Maybe more on that later.

However, I have several other TT's that I like to rotate in to my living room from time to time. To keep from having to disconnect the main Dual, I purchased an Emotiva XPS-1 phono preamp and would connect that device to one of the other HK 990 RCA inputs (such as CD or tuner). I then connect whatever TT I desire to the Emotiva (along with ground wire to Emotiva). Note that the separate phono pre has a power supply connected to same wall outlet.

One afternoon I decided to connect a Sony TT to the XPS-1 and do some listening (I had a new stylus I wanted to hear). After listening a bit I was changing volume with the remote and all of the sudden the volume rapidly started getting louder and louder (the number in display was not changing). It quickly rose to deafening sound and I rushed across the room to turn it down as the remote was not helping. I visible was horrified at the head-busting distorted sound and the noticed the drivers on my KEF's were going to maximum displacement.I hit the power button and started to cringe as I thought the worst had happened to my system and fairly newly purchase KEFs.

I monitored things closely as I powered it back on and tried to listen to the Sony TT again. After a few minutes the volume started to runaway again but I shut it down before it got out of hand.

I disconnected the Emotiva amp (thus the Sony TT too). I was able to safely listen to the other inputs (inlcuding Dual TT) just fine from then on. Luckily my system was unharmed and the KEFs are fine :).

After a few days I decided to troubleshoot this and I removed the Dual from the system. I then connected the Sony T to the primary MM inputs on the HK 990. No problem, I never had the runaway volume issue. Weeks went by and I wanted to try the 2 turntable setup again and I redid the same configuration as before (Dual on primary inputs, Sony on Emotiva). The volume got wacky once again after some time and I decided I simply cannot have the Emotiva plugged into the other inputs, there is something electrical that is causing the HK 990's computer or outputs to go nuts.

After seeing your comments. It does seem possbly related to the ground loop. Let me know the european forum link... I would like to compare notes.

I don't want to change to a different amp as it does everything I need (I just have to be careful with the 2 tt setup) and I love the sound too much. It is an incredible combination with the KEF's which ar3 4-6 ohm speakers and the HK is perfect for them as it can push 300 watts to 4 ohms!

However, I am going to audition a Schiit Uber DAC this weekend with the HK 990 to see how external DAC compares with the included one.
Very informative. Thanks. I think lurking is good. I should have done more of that.

FWIW, it seems to me no doubt that your experience supports the ground loop theory. I'm sure Steve Nugent from Empirical Audio would have a comment. He probably doesn't read this particular forum. But it wouldn't hurt to ask.

When I was a newbie years ago and there was no internet for support, I drove a rod into the ground outside my window and grounded my system to it. I thought the sound was improved. I asked my dealer about it, and he gave me that "you're really going off the edge" look. So I thought I must have had a good imagination in the same way that placebos work well sometimes. Now I think I should try again. Connecting a ground to plumbing might work too.

I can't give you info on the European forum. I've had emails from Europeans, and sounds like the hk990 is popular there. Someone else here probably can.

I wouldn't be so sure that the hk990 is rare. HK isn't popular on audiogon, but I suspect sales are good or it would have been discontinued. The absence of hdmi in the hk990 ( I think it came out in Europe in '09) outdates it and should make it unattractive to consumers. But I think that the SQ combined with advantages it has over separates has earned it a market share. I think hk stock doubled last year on NYSE.
Here is the URL to the Euro thread I mentioned. You will need to have your browser translate as it is primarily in French. Also note the length of this thread. It has been several months since I read this thread, so I can't say specifically where the "runaway volume" issue was first mentioned (it seems like it was in the first 100 pages or so). I have not had a repeat occurrence of the incident I described, but it sounds like you are on to something with your assessment. Thanks for your input and here is the link to the thread:

http://www.homecinema-fr.com/forum/amplificateurs-integres-haute-fidelite/ampli-harman-kardon-hk-990-t29899384.html
I have a faulty HK990. When I connect an optical input and switch on the amp, it throws an error 005 followed by a message DSP firmware corrupt, reload DSP firmware. I have tried the firmware reset procedure of using Speaker1 and Level button, but the error still shows up.

Now, if I don't connect an optical input, there is no error, but there is no sound even in direct path setting.

Googling gave some pointers to a faulty SRC 4392 chip. If that is indeed the case, is it just about replacing that chip or this is something only Harman Kardon can do because SRC 4392 has some HK firmware?

I have approached Harman Kardon in India and they have been very reluctant to help.

Any help will be really helpful. What are my options without having to go through HK?