The speakers are too close to the wall. How long will it take for you folks to realize that the combination of equipment and the way you push minute voltage fluctuations through wire and fuses pales in comparison to the importance of how your ears are pressurized by the speakers in the listening environment, and the resultant effect not only on sound quality, but also musical involvement? Opera lover - your speakers are improperly placed and positioned, plain and simple - moving them to where they belong, mot just where they fit is the solution to your problem. MySpeakerSetup.com - read and learn- then talk to me!
Bass is not enough !!! Speaker problem? Speaker cable? Power Amp? PC of Power Amp?
The bass is not enough!! Not sure which part is not good enough. Can anyone give any idea??
My system:
Speaker: Sonus Faber Amati (SC = Jorma Prime)
Power amp: Esoteric A80 mono blocks (IC = Transparent Opus MM )
Pre-amp: Esoteric C-02 (PC = Jorma Prime)
PC for Power Amp:
I had been using BMI Oceanic Statement。The sound was beautiful, but the bass was not low enough.
I changed to NBS Black Label II 。The bass was better, but still it was not good enough. However, the sound was not as good as BMI Oceanic Statement. So now I have changed back to BMI .
How I can improve the bass performance??
Amati's weak point is bass? Jorma Prime's bass is weak?
Thanks!!
- ...
- 51 posts total
According to your statements, all components including speakers match each other and only option left to exercise is your personal hearing. For this you'll need to actually measure frequency response in your room http://http//www.raecorents.com/products/noise/3M-Quest-Edge-eg5/?_vsrefdom=ppcgoogle&ex=oerf7a-eep549-1ojahoy&gclid=CN71jfO4mMoCFU4WHwod-CICiw Did you try any other amplification? Why did you decide on Esoteric? Was there ever enough bass in your system current or previous? What compares to what you've heard before? How old are your speakers and how many hours they've played so far? |
Tomorrow I am going to try removing wellfloat board from the source. If the improvement is there, I am going to remove all wellfloat board and BDR carbon fiber board. I am also going to try removing spike base or TACO board or both from the speakers to see whether it is the problem. I hope the above could improve (regardless bog or small), or.... |
- 51 posts total