Backup battery UPS for my system...



Does anyone have any recommendations?

What are you currently using and why did you choose it?

Many thanks,

Charles
cfarlie
I use a APC unit that gives me about 5min power to get Projector and amps shut down, I really just use it for Projector......its nice to run a lamp for a couple hours and charge cell phone in emergency. If you shut donw stuff quick it can handle small loads for a good amount of time.
I use a Cyberpower UPS, made for computers and purchased 6 years ago for under $100. I had to replace the lead acid battery once 2 years ago for $35. I use it mainly to protect the DSP-based pre-pro from voltage dips caused by my amps turning on. The voltage dips were causing the pre-pro (Sherwood-Newcastle P-965) to malfunction. Problem solved with UPS.

Chad, I'm surprised you are able to use your battery backup with your amps. Most battery backups I have seen have wattage/current limits well below that demanded by a decent-sized amplifier.
I share Javachips reaction to using a UPS on an amp. If you search the forums you will be hard pressed to find anyone doing or advising this. In fact most consider this to be a big no-no especially with amps. Props to Chadnliz for doing his own evaluation!

When I redid my HT I put in a UPS specifically to handle the DirectTV DVR and AppleTV which are in fact computers with hard drives.

Everything else runs into a BPT (no battery backup) then into a wall.

Let us know what you end up with.
Only my HT amp is in that unit, the 2 channel monsters and all the rest of my sterao gear are not on that line. Sorry I didnt clarify but again my biggest concern was the Projector and some of the more memory sensitive gear thats a pain to set up after a blink out.
The double-conversion type re-create the power, but it's hard to say if it's a stepped-sine or true-sine output. The stepped-sine is going to have a boatload of harmonics on it.

I have a Best Power Ferrups FE at home that is double-conversion and isolated. True sine output. The Liebert GXT looks to be that type too. They can be loud, so be careful what you choose.

My big APC units at the lab are double conversion and stepped sine. Very small steps, but stepped.