Thanks, Mapman. On June 11 and June 12 I had posted the following in this thread:
Best regards,
-- Al
Regarding interconnects, if I recall correctly all of the equipment possibilities that have been mentioned would be suitable for use with balanced XLR interconnects. While opinions about cable selection tend to be all over the map, as you may have seen in any number of other cable-related threads, FWIW my suggestion is that initially, at least, you simply purchase some inexpensive Mogami Gold Studio balanced cables. And who knows, despite their modest price you may find them to be suitable for use permanently.Regarding the comments about low capacitance in my posts earlier today, the capacitance per unit length of Mogami Gold Studio is somewhat higher than in the case of most of the cables Guido suggested, but the short length that is required should make that difference inconsequential.
Those cables, by the way, are the de facto interconnect of choice in professional recording studios worldwide....
... Regarding the interconnects that would be used at the output of the Aeris DAC, I note the following statement in the Aeris’ description:
Transformer balanced XLR line outputs provide outstanding output common-mode noise rejection, eliminate potential ground loops, and ensure compatibility with other equipment.I also note that it has a 120 ohm output impedance, which although not especially low is considerably lower than in many other designs.
I suspect that those factors will result in that DAC having somewhat less sensitivity to cable differences (at its balanced analog outputs) than would be the case in many other circumstances. Especially if the length that is necessary is only 1 meter, as most analog cable effects are proportional to length.
Best regards,
-- Al