Is DEQX a game changer?

Thanks everyone for your help. I emailed DEQX yesterday and they emailed me back the download file for the mic. After fiddling with that download for a while and rebooting it now shows the mic installed.

However, dummy me, the volume setting was set too high (max) and I blew out a tweeter. I hope to have its replacement tomorrow.

So, I measured the good speaker and then copied those results to the other, then I did my subs.

Once the replacement tweeter is installed, I’ll do the room correction. But, I can already tell that as I get more familiar with the screens and settings I will redo the tests.

Almarg, The mic I have is good to start with, perhaps down the road I will either rent or buy the more expensive one.

Ok, I've done the speaker measurements and with the dual JL Audio subs and the room calibration. What I found was that it is better to calibrate the JL Audio subs with there own microphone before using the DEQX with them.

I still need to figure out the delay functions and many of the other tweaks.

Does anyone think if there is a breakin time for the unit? I am using it as a Preamp so I assume like most things audio 200 hours of use time seems to be about right.

I also ordered a SR black fuse to match with all my other equipment.

One more question.

For those who own the BSG QOL, should the QOL be placed before the DEQX or after?

Does anyone think if there is a breakin time for the unit? I am using it as a Preamp so I assume like most things audio 200 hours of use time seems to be about right.

drewan,

Though the Premate unit was purchased as used, I was told that it was never used just the box was opened up. Perhaps it was used as a demo. Everything about it looks brand new.

Thanks for your comments on the BSG QOL. Tomorrow, I will try the high analog output from the DEQX into the QOL with the QOL then going to my amp. My logic is that I have the speakers and room set up with the DEQX, so I should be able to hear what the QOL adds. But, I also intend to try it the other way too, that is before the DEQX.

I changed the fuse to the SR Black, but I am confused. The unit says to use a 2A fuse but what was in it was a 1Amp.

I also changed the jumpers settings, while inside I noticed that the mother board says HDP-4 which is perhaps a good thing. But, on the power cables going to the IEC there is a cheapo snap on RCA ferret, perhaps a bad thing.

ozzy