ARCAM AVR600 Reliability Issues



I'm considering the purchase of an ARCAM AVR600 but have read a lot of older posts on various forums about reliability/operational issues with it - weird noises from the speakers, the unit freezes up, random volume changes, etc.

Has anyone had similar experiences? Have the more recent firmware updates addressed these issues?

The sound of the ARCAM blew me away but I don't want to invest in a piece that's going to drive us crazy. I'm also considering the Integra 80.3 and the NAD T187 to use with my existing power amps. Any thoughts on those units in comparison to the ARCAM?
audioengineer99
I wanted the avr600 but as you say, many posted some issues with it I also wanted the 1.4 hdmi.
I finally bought the Arcam avr400 1.4 hdmi 90w pc x7, plenty of power and very happy with it, about a year now never an issue.
hope this helps
Here's what I've experienced with my Arcam AVR600 (the model with 3D)...you may find it hard to believe but it's all true.

I'm an extremely patient person but enough is enough. I've had 6 brand new Arcam AVR600's in the last 8 months. One was received DOA but each of the other 5 were installed in my home and they ALL had a tremendous amount of issues not to mention their repeated attempts to blowout my tweeters in my B&W 802D's and HTM2 speakers!! I'm going out of my mind with all the daily problems with EVERY unit I receive!!! Each unit has had the sound delay/sync with video issue, the LOUD POP out the DB1 sub, and of course the LOUD SNAP out the speakers as the Arcam tries to blowout my tweeters when it shuts off during use (and this happens regardless of the volume setting...it even does it when on MUTE) and then immediately powers back on only to do the LOUD SNAP again and repeat the cycle over and over until I physically turn the unit off with the power button on the front of the unit...the remote will not turn the unit off when it's doing this malfunction. On a less frequent basis I'll get 8 - 10 LOUD POPS out the sub rather then just a single LOUD POP out the sub, and at times I’ll get LOUD POPS out the 802's also. Whenever mute is activated, the sound is terrible for approximately 3 - 5 seconds when the mute is turned off.

When the unit works properly I do like the sound...it sounds very good IMHO. But even if it had only one of the above, very frequent, daily issues I would not keep the unit. For $6000.00 MSRP it should work flawlessly. Needless to say, this extremely patient person has reached the end of the line with his Arcam AVR600. After 8 months of torment and 6 new units none of which having had any improvement during the 8 month timeframe, it's going back for a refund. Can't say I didn't try to make this work. Sure wish Arcam would have made an attempt to fix their problems cause it does sound very good when it works.
Jeez Cayman I would have thrown the towel in after a 3rd defective unit, at most.
For 6 grand not only should it work flawlessly but the dealer should come to your dwelling to ensure that it does.
The sound is truly superb.

Mine does the pops too but only on the DVD input (from an OPPO BDP-83), and only when a DVD is first booted up in the start-up menu, in which case I merely hit Mute till the audio codec displays on the Arcam.

Mine has the latest firmware but not the 3D board.
I am on my second AVR 600 and dealing with the same POPs followed by the unit shutting down and then starting again. Have to send this one back as well. I am so frustrated by the situation...I really want to use the product...but this is unacceptable for 6k.