god i just looked that those http://www.atma-sphere.com/Products/#MA-3 hate to have to re-tube them suckers nothing like ordering 108 tubes matched at one shot haha.... owch
Tube vs Solid State
Folks,
For past few months, I have been trying to achieve best possible sound in my rig. The focus now is clearly on a improving 2 channel sound in what started as a home theater room.
In past couple of years, I have added N10, Modwright DAC and very recently a LS36.5 linestage . The amps are Modwright KWA150SE. I am running pair of KWA150SE's in bridge mode (450Wx1) for the mighty B&W 800D2's. While I like the sound as is, still feel something is missing.
I have been toying with the idea of bi-amping. One thought is to add mono tube amps to run mid's and high's and let the KWA150SE's handle the LF's. I am pursuing that seductive, slightly warm mid-range and top end that usually comes from tube amplification.
I don't think there is any tube amp out there by itself capable of powering up bass hungry 800's. I prefer not to use a subwoofer in 2 channel setup. I listen to mostly jazz and classical music and quite sure that 800's are capable of producing adequate bass with proper amplification.
Any feedback would be appreciated.
Cheers!
For past few months, I have been trying to achieve best possible sound in my rig. The focus now is clearly on a improving 2 channel sound in what started as a home theater room.
In past couple of years, I have added N10, Modwright DAC and very recently a LS36.5 linestage . The amps are Modwright KWA150SE. I am running pair of KWA150SE's in bridge mode (450Wx1) for the mighty B&W 800D2's. While I like the sound as is, still feel something is missing.
I have been toying with the idea of bi-amping. One thought is to add mono tube amps to run mid's and high's and let the KWA150SE's handle the LF's. I am pursuing that seductive, slightly warm mid-range and top end that usually comes from tube amplification.
I don't think there is any tube amp out there by itself capable of powering up bass hungry 800's. I prefer not to use a subwoofer in 2 channel setup. I listen to mostly jazz and classical music and quite sure that 800's are capable of producing adequate bass with proper amplification.
Any feedback would be appreciated.
Cheers!
- ...
- 61 posts total
Modwright KWA150SEThe 800D/2/3 are a bit of a vicious load not just in the bass which can get down to an "EPDR" ( equivalent peak dissipation resistance) of around 1ohm, but also in the 8khz which can get to an EPDR of around 3ohms. http://www.stereophile.com/images/511B800fig1.jpg Your KWA150SE is a very good amp to drive nasty loads with as it is bi-polar output, and having 6 pairs of them per channel, so it should do great current drive into those loads, better than tubes or mosfets Have you tried to use it in high bias class-A mode?, (switch on the back) as this should sweeten things up and not sacrifice any solid state detail and dynamics. Cheers George |
- 61 posts total