2. misc-audio
  3. 128728-1324

A Big DIY Bang for Your Buck?

I believe in getting the biggest bang out of my audio buck that I can. I don't know about you but my audio budget is actually limited. I find it interesting when I hear about folks spending a zillion on the best magnetic cables and then someone comes along with some new cable technology like new liquid-infused cables that equal or best the magnetic cables at a fraction of the price. Some makers of magnetic and other cables may want you to believe that a patent pending means there must be something there that ordinary Joe Audio could never make himself. My experience leads me to say -- don't believe it.

I have been using neodymium magnets for years in my cables and around my system to improve SQ -- at a fraction of the cost that makers of magnet-containing products charge. OK, mine may not be at the very top of the performance chain when compared to those expensive products, but who cares? I have managed to get stunning returns for a pittance. It would have cost thousands, or tens of thousands, to obtain similar results from various makers.

The same applies to audio makers with a patent pending (or an actual patent) who market little aluminum audio resonators the size of pimples. I make my own resonator pimples for about a buck apiece -- with stunning results. I saved over $4,000 making 70 of my own. Maybe they are not at the very top of the performance chain compared to those expensive products, but who cares? I am very happy with results that are far beyond what I expected when I started out.

I am having a lot of fun doing DIY projects at home that reap wonderful results at a small fraction of the cost charged by audio makers for their similar products. Have others had similar experiences making their own audio products at home? Can you share your DIY experiences with us?
sabai
herman
1,974 posts
 


For me this is not an intellectual or scientific pursuit. It is strictly a pursuit of the best possible sound. My ears have been tested to 18000Hz. I trust my ears.

Brilliant!
geoffkait's avatar
geoffkait
14,147 posts
 

sabai OP
geoffkait,

It improves the sound by affecting the signal.

You've been hoodwinked, Sabai. When magnets are used around the room, on chassis, on walls, on wood shelves, on mirrors, on glass, they have no bearing whatsoever on the signal.  Now, somebody might find some rare instance where magnet affect the signal in a positive way, but usually magnetic fields hurt the sound, which I've stated pointed out. You know, the magnetic field from transformers and the induced field from current traveling down wire. The latter is why the magnetic conduction cables sound so good, or so it would appear from all the hoopla. But not because magnets affect the signal like your thinking. In fact you yourself use magnets in the connector not on the wire. Do you think the magnets are attracting electrons or photons? give me a break! The magnetic conduction cables address the induced magnetic field in at least two ways I can see.

sabai OP
2,027 posts
 
geoffkait,

Hoodwinked by my ears. Of course, the signal is affected with the magnets in the connectors -- as well as by a packet of 12 magnets below and 12 above the breaker box.
geoffkait's avatar
geoffkait
14,147 posts
 
I already stated the signal IS affected by magnets. Just not in a good way. Let me give you an example. If you remove the steel I.e., magnetic door from the circuit breaker box the sound will improve significantly. Putting the magnetic door back on degrades the sound. Plus the reason manufacturers went from steel chassis to aluminum chassis was primarily a sound issue. If you like the sound of magnetic chassis then steel chassis is for you.

sabai OP
2,027 posts
 
geoffkait,

You're right. The signal is affected by magnets. Just not in a good way. In a very good way.

I am not touching my breaker.
More to discover