Converting Solid State to Tube Rectification on a Preamp


I am looking to convert my Preamp from a Bridge Rectifier to a Tube Rectifier.  Any members have done or knows how to do this. Your help are much appreciated!


128x128zipost

@salectric

I might be lost in translations, but full-wave bridge superposes 4x(as signal is phase split by 180deg) half-waves thus pulsation is substantially smoother than to the conventional full-wave method or tube rectification. Literally saying that you’re dealing with 4 superposed half-waves as opposed to 2 superposed half-waves.

Pulsation of bridge is nearly 4 times lower in magnitude and closer to the perfect DC.


That's true.  The DC from a full-wave bridge should in theory be a bit smoother, but I doubt that would make any difference in a preamp.
If you haven’t already, try some ultrafast/soft recovery HEXFREDs first. Much simpler, and may satisfy your desire for improved sound. ie: (http://www.partsconnexion.com/rectifier_diode_fred.html) &(http://www.partsconnexion.com/rectifier_bridge_hex.html) There’s a blurb on potential benefits, on this page: (https://www.caryaudio.com/upgrades-and-modifications/
I have a Blue Circle 21 preamp. Output tubes are 6sn7 with a solid state bridge rectifier. I want to replace that solid state bridge rectifier with a tube say 6x5. I will be using the existing 6v for the heater or running on battery for the heater. My questions are:

1)  curently the unit is running on a bridge rectifier, if i convert it to tube, then it has to be half wave rectifier.   To run the preamp at full wave, a pair of two 6x5 are needed?  

2) if i do make that change to a single 6x5 tube rectifier, with the preamp does it matter if i do run it in a half wave or full wave??

3) does anyone knows how to do this, if you can help me out??

Much appreciated!!