Acoustat 2+2...Any users?


Hi all, Picked up a used pair of 2+2's for a good price and from a very nice guy. I was wondering if any body out there is still using these classics. I am on a speaker reviewing frenzy trying to find out what sounds best in my living room. Also own Martin Logan ReQuest's, Quad ESL 63's. Also would like to know if anybody knows of someone that supplies spare parts or services the Acoustat's incase ever needed. Thanks, Bob
telescope_trade
Yes, Bob, you are not alone. There are lots of us out there! I made the mistake of selling mine five years ago but was recently lucky enough to be able to buy them back. And I see that somebody at this site just 'lucked into' a pair for $825! [maybe you?] Audiophiles are crazy if they overlook classics like the 2+2s. Among many other features I must comment on their durability. In the unlikely event that you ever need service, do a search at Audio Asylum for lots of posts on this subject. Let us know how they compare with your other stats.
Barry, Yes that was me who got the 2+2's :o). I am going to the airport today to pick up the Quads, and will have the Acoustat's Monday or Tuesday. So I will have a big shootout here for a few day's. (Bummer huh?) Thanks for the reply, that's great to know that they are very durable, and will check the site you mentioned. Will report back later! Thanks, Bob
BOB: Before I migrated to audiophile surround, I listened to 2-channel for several years on a pair of Acoustat 2+2's modified by myself for optimized sound. Some tips: 1 Sound best without socks - by far! To operate without socks and still preserve WAF, you must improve the appearance of the frames (which, incidentally, improves the sound by removing square corner diffraction). Remove socks. Remove electro panels and crossover/transformers. Remove base plate. Rout a round shape into all sharp edges. Fill and paint frames. Reassemble without socks. I used an antique white that complemented the plastic flourescent light grids that are used as front and back speaker panel members. 2 Replace all caps in the crossover with audiphile variety, such as Wondercap. Big difference. 3 After you have found the best setting on the large variable power resistor, measure the resistance at that point. Then replace the entire resistor with a film-type power resistor of that value on a large heat sink. Huge improvement! 4 Make sure you have spike in the base plate. Then devise a turnbuckle system, like a small floor jack, that you can place between the tops of the speakers and the cieling, so you can screw the speakers into place with tension between the floor and the ceiling. Much more definition in the sound, top to bottom. 5 I had to carpet the entire wall behind the 2+2's to deaden the rear wall reflections. Otherwise, I was forced to play them 1/3 of the way out into the room! You may want to carpet or drape the entire area behind them. 6 Tune them by establishing your sweet spot, then aiming the left speaker at your left shoulder, and the right speaker at your right shoulder. Use a level to make sure they are vertical to the floor - this angle doesn't change. 7 Pound in a proprietary ground pole. Lift the house ground to your audio circuits and replace with the proprietary ground. Makes a difference in all systems, but even more so with electrostatics. My audiophile surround is an improvement over 2-channel, in part because I play into 13000 cubic feet. I have no room reflection problems, and can enjoy all the power inherent in 6 audio channels, 12 amplication channels and tons of drivers. But for 2 channel listening, I never heard anything better or more sensitive than those 2+2's with Krell amp and passive pre-amp. PS - never use a powered pre-amp with the 2+2's, if your DAC has enough power to drive your amp through a passive pre-amp. You end up hearing all the problems with your pre-amp rather than listening to the music. Bruce Kopitz