Warm-up time.


It takes about an hour of loud playing for my system to come to life, whether it's digital or analog.
i was wondering if it's the amp or the preamp that needs the warm-up, or both.
i have a vintage modified CJ preamp, and modified NuForce Class D mono blocks.
128x128rvpiano
It takes 2-4 hours for my high-end SS amp and high-end valve CD / DAC system to warm up to hit its peak performance capabilities. It is a very common practice, especially with tubes.

But it does not involve playing it loud, or even playing it all during this start-up ""warm-up" logistics exercise. Rather  just letting it all calmly warm up slowly on its own and actually leaving it alone suffices. 

I'm puzzled by the OP's gear requirement to crank it up as his required modus operandi. 
It takes my rig about 40 minutes to start sounding awesome, an hour gets me where I want to be.  On vinyl, I hear improvement after the 1st side.  After a 2nd side, its pure bliss.  
In your tube component especially, warmup is essential to prime listening. The nodes must be burning for a while before the electrons fly across those gaps in a smooth unwavering flow. Keeping the component on all the time can keep your electric meter spinning as it can generate much heat, depending upon the tube type. But you wouldn't have to remember ahead of time to turn it on.
I've never found the need or noticed any difference in playing music during warm up. I come home, turn it on and putz around and then start playing music awhile later. 

It takes my system about 30-45 minutes before it 'gets going'.  I wonder, though, if just leaving the system powered on does the trick, or if you actually have to be sending signal through for it to make a difference.