Help needed for a skeptic!


I admit I am a cable skeptic and think spending $6k on a set of interconnects is loonie!
I have a set of YG Anat 3’s driven by Chord amps. I am using a Krell Foundation pre-amp. It is driven by a Chord DSX-1000. I have good hardware. I have been reluctant to spend too much on wire do to mu  meeter going off every time I look. I am using balanced interconnects. Mostly Straightwire. My question is what would those who post suggest for speaker wire. I do Bi-Amp my YG’s Right now I am using some Nordost flat cable knock offs. My sound is great but I think a little compressed for my equipment. If one were to try an upgrade on speaker wire under $1000 to bi-amp what are your suggestions?
drjsmd
What about Van Damme Hi-Fi UP LC-OFC 6mm, or 4mm, terminated by you with pure copper BFA plugs Furez TSTSB50NP.

I would be very surprised if that does not make the best possible connection.
go to the lending library at   THECABLECOMPANY.COM


there is only one way to determine how a cable will sound in your system, play it in your system !
...as sc4a notes, 'the proof is in the ...' cable instead of pudding....

Pudding and electronics of any sort and/or flavor is just a mess...;)

Happy New Year....and hopefully not the entire one spent on the search....*G*
if your sound is a little compressed, try addressing the grounds and buy an isolation transformer

after that, go to one of the rental cable places as per above