Stereo Guy - Need advice on HT integration

Are you planning to use your Avalon Times driven by your JE amps as front mains in your HT setup?

If so, I would suggest looking for a nice stereo preamp that has a HT processor throughput (many good ones do), and using a HT receiver for your surrounds and sub HT needs.
When I was doing this, I found this MUCH more satisfactory then any SSP that I tried. I never found any SSP to sound musical on two channel stereo music, not even "high end" brands like Classe, Mark Levinson, Krell.

For me, the best sound in stereo was achieved  using a stereo preamp for 2 channel audio purposes, then just adding a HT Receiver accessed through the stereo preamp HT Processor loop.

Good luck!

Thank you everyone for your input - much appreciated.
jmcgrogan2.  Yes, this the kind of solution I was hoping for.  I should have mentioned that I was looking for a 5.1 HT system.  I have the other speakers and subs but no other amplifiers.   As to whether the JE are used in HT I’m not sure.  It might not be suitable but sounds fantastic in 2 channel.  If i got a stronger 5.1 receiver/processor capable of driving Avalons in HT mode i would have come up with a way to switch inputs to the speakers.  What HT processors with HT pass through do you recommend?

it's your preamp that needs HT passthrough, not the HT Processor. What the Passthrough does is take your front L/R outs from your HT pre/pro into your stereo preamp which sends it to your front (Joule) amp. If your preamp doesn't have passthrough you can use a spare input from your preamp for this purpose, but its less ideal.

Your notion of driving your Avalons with 2 different power amps and switching between them is the least ideal way of all IMHO.  

^^^ @bdgregory  is correct. The HT passthrough is a feature on a stereo preamp that allows you to use your stereo speakers and amp(s) as front mains in a 5.1 HT setup. If you do not plan to use your JE amps in the 5.1 setup, there would be no reason to do this.

However, driving one pair of speakers with two different amplifiers (one for audio, one for HT) can be a tricky setup. It can easily lead to speaker/amplifier damage if not carefully done.

To do this right, I would think that you would have to switch your speaker cables from your JE amps to the HT Receiver when switching to HT, and then back to the JE amps when listening to stereo.

+1 jmc and bdgreg. A stereo pre configured the way they said with a decent AVR is absolutely the way to go if 2-channel music is the priority.  You can use any stereo pre, and if it doesn't have a HT bypass you can use any open input and just set a reference level (I used 12:00 to make it easy) so the front L/R speakers have the proper volume set for HT.  Shame to spend tubes on HT (unless they’re really cheap to replace), so I’d probably be in the camp of disconnecting the Joules and hooking up to the AVR for HT duties.

Obviously you’ll need an AVR with preamp outs for this to work. I’m in the process of getting one of these too, and FWIW I’m getting the Yamaha Aventage 870 from accessories4less for $650. I think Yamaha has the best combination of features, performance, reliability, and value. Best of luck.