This bit is problematic. The drivers are going to sound the same whether in parallel or in series. What **won’t** sound the same is the amplifier, which reacts very differently to impedance depending on the amp.
Hi Ralph,
I believe that I did elude to the fact that it is the amp that sound differently, but I want to stress that in this case, compensation circuitry should sound better with tubes that the speaker without the circuitry.
Using 2 - 16 ohm speakers, depending on frequency, you will see impedances normally rise to 30 or 40 ohms if not higher. You can obviously go into why and amp sounds better on 8 ohms than 4. Impedance compensation circuitry normally only lowers the peaks (stated for others on the thread), it never raises an impedance dip. So when we can make a speaker consistent from say 8 to 9 ohms, in my experience A tubed amplifier putting out consistent power across all frequencies has always sounded better than an amp that sees a speaker that strays radically. Again, this is only my experience, today, I seldom build a speaker without compensation, there are a few exceptions, but Few.
Hi Ralph,
I believe that I did elude to the fact that it is the amp that sound differently, but I want to stress that in this case, compensation circuitry should sound better with tubes that the speaker without the circuitry.
Using 2 - 16 ohm speakers, depending on frequency, you will see impedances normally rise to 30 or 40 ohms if not higher. You can obviously go into why and amp sounds better on 8 ohms than 4. Impedance compensation circuitry normally only lowers the peaks (stated for others on the thread), it never raises an impedance dip. So when we can make a speaker consistent from say 8 to 9 ohms, in my experience A tubed amplifier putting out consistent power across all frequencies has always sounded better than an amp that sees a speaker that strays radically. Again, this is only my experience, today, I seldom build a speaker without compensation, there are a few exceptions, but Few.