A Question on Speaker Driver Efficiency

As quoted by CJ1965:

" So if you have a 97 db 1 watt/1 meter 8 ohm driver, two in series will have the same efficiency (since each is absorbing 1/2 watt) while the sensitivity is 94 db " - atmashpere [sic]

Given that efficiency is defined as the SPL produced at 1 meter in response to 1 watt, when he said "since each is absorbing 1/2 watt" he clearly meant "since each is absorbing 1/2 watt if a total of 1 watt is being provided." Also, the paragraph in which that statement appeared certainly made no reference to 2.83 volts.

If that was not clear then it certainly should have become clear during the course of the subsequent posts, especially mine.

... you can double the input drive voltage to 5.7v and then the series arrangement will have each woofer dissipating 1/2 watt. You can also multiply the input voltage by 10,000 - it won’t tell us anything about the effect placing two identical drivers in series has.

Specifying the efficiency of a series combination of speakers, defining efficiency as the SPL produced at 1 meter in response to 1 watt, will tell us whatever can be told by an efficiency spec. As Ralph alluded to earlier, efficiency specs tend to be especially relevant in the case of tube amps, since for example in the case of an amp providing 4 and 8 ohm output taps maximum power ratings (in watts) will typically be the same or similar when an 8 ohm load is connected to the 8 ohm tap as when a 4 ohm load is connected to the 4 ohm tap.

Regards,
-- Al

Each is not absorbing 1/2 watt when placed in series (with the required 2.83 V applied) and the net acoustical sum of output is approximately 97db - not 94db. Two obvious errors in one sentence. The math doesn't lie and frankly, I'm getting a little tired of the verbal gymnastics at this point. The math is simple and anyone who wants to read the details above can readily see where the error was established. Yeah, you can double the input drive voltage to 5.7v and then the series arrangement will have each woofer dissipating 1/2 watt. You can also multiply the input voltage by 10,000 - it won't tell us anything about the effect placing two identical drivers in series has.

@almarg  Its pretty evident to me that this guy seems to equate '1 watt' with '2.83v' and so is somehow assuming that I meant '2.83 volts' when I was pretty talking about the power (not voltage) being '1 watt'.

Also his intuitive grasp of Kirchoff's Law seems to be weak, and I further find that talking about capacitance when dealing with 2 guitar speakers as opposed to one rather silly, since any such distributed capacitance on the coils (or anywhere else) is going to be quite low and negligible. But even if it was not, in a series connection current would have to flow through both drivers in order for one to work. For all his 'hand waving', he seems to have no grasp of the formulae he presented, how they are used or their significance. 

@kijanki +1

@cj165
I'm sorry, I would call you by name, but I haven't seen it posted.  I came very close to sending this in a private message, but much has been addressed in this thread as well as a couple of others. 
1st... You are extremely knowledgeable and could be if you chose to be, a very strong contributing member to this forum. I personally would love to see that happen. 
You have 7 pages of responses, I did not count the threads, but I would guess maybe 8 or 10.  In those threads I read maybe 20 or so of the post.  In each thread at some point, you belittled someone. 
Odd that one of your threads, you discussed heavily forum etiquette, I believe the thread was discussing if someone needed to prove that they were qualified to chime in on these forums.  
I would say that 98 percent of the members here come here to learn and share the passion of their hobby.  All of us at some point get challenged with our knowledge and being the he men that we are, we seem to have to defend ourselves (except maybe Elizabeth and you attacked her also). I'm not sure if you are trying to prove something or are insecure in yourself that you have to feel superior over others?  Really, I'm not try form a conjecture.  I am really hoping that you are here wanting to contribute and would take it serious that we are all people, all have feelings and all want to be treated with respect. There is no doubt, that I have said stupid things on this forum that can and have been challenged, On the other hand,  there is no doubt, that I have made a difference and contributed to others personal audio issues.  Your knowledge in most area's of audio make my knowledge a pittance,  but I can tell you if the disrespect continues, I will turn you off.  I appreciate your knowledge level and am hoping to appreciate you personally for your contributions.  
I am trying to say all of this in respect.  
Tim (timlub)  

Timlub +1

@timlub +1