2. amps-preamps
  3. 137268-517

Backert Labs Rhumba preamp

Hello,
I am thinking of going to an active line stage for sometime now. I have a separate thread for that and people have suggested some good choices. The reason for this thread if that, while I have all along said that  don't want tubes in the system, a few have convinced me that I should try tubes in the system, especially with ProAcs.
With that said, I researched a few tube preamps, that have XLR out and the Backert Labs Rhumba is the one that has only 2 tubes, which makes me comfortable to "deal in tubes".

I would like to hear from Backert Labs Rhumba owners who moved from Solid State preamplification to this preamp. What are the differences you heard? Any improvements?

I read a review on the Stevehoffman forum and the user mentioned that there is a "hum" in this preamp. This bothers me and hence I decided to check on this forum, if anyone has experienced this with the Rhumba in their system. One poster on this forum also confirmed the "hiss":
https://forum.audiogon.com/discussions/backert-preamps-any-users

So I was wondering, if there are any users who have recently purchased this preamp and what is their experience with the hum/hiss issue.

BTW, I blame Ralph of Atma-Sphere, Almarg  and my dealer for making me consider tube amps :-) Can't believe I am creating this thread.

Thanks!
128x128milpai
hifiman5's avatar
hifiman5
1,611 posts
 
@philipwu   How would you characterize the sonic difference between the two Backert line stages?
milpai's avatar
milpai OP
1,341 posts
 
Thank You @audiothesis and @philipwu 

@philipwu ,
Do you have the Rhythm 1.1 or the 1.2? Like hifiman5, I would like to hear about the differences between your Rhythm and the Rhumba that you previously owned. Now was that Rhumba 1.1 or 1.2?
milpai's avatar
milpai OP
1,341 posts
 
Folks,
One question - when I think about tubes and the demos at audio shows it was always some vocals or smokey jazz or classical. But I do occasionally listen (and I am not bashful about it) to Michael Jackson, George Michael, etc - so pop from 80s/90s. My kids do sometimes come into the room and listen to the current pop like Justin Beiber, Uncle Kracker, etc. How does this kind of music sound with tubes? With my TVC, it sounds pretty transparent and clean. Does tubes make this kind of music sound "slow and syrupy"? Will I have to keep switching between the tube preamp and the TVC to get best of both worlds? Mind you - I listen to female/male vocals, classic rock, jazz and classical 80-85% of the time.
atmasphere's avatar
atmasphere
7,068 posts
 
It also doesn't necessarily mean a balanced connection or a fully balanced design circuit (i.e MP-3) will give you lower noise or have any advantage over single ended design. Fully balance design circuit will also susceptible to hum problems too.
Just a correction here, since this statement is essentially false.
The advantage that balanced operation has is several- immunity to interconnect cables, and the system was also devised to prevent ground loop hum and it works quite well! "Fully balanced design circuit" (sic) is far less susceptible to hum problems- it is better able to reject noise in the power supply and far more able to reject hum from close by power transformers and the like. It is also possible to get lower noise, since if the balanced design is also differential, careful use of well-designed constant current sources will reduce noise while also increasing gain and reducing distortion.
The first bit: immunity to interconnect cables, is likely the most important aspect, since audiophiles are well-known to pay serious money for interconnect cables in search of the cable to rule them all. In effect, cables are the 'hidden cost' of operating single-ended preamps.
hifiman5's avatar
hifiman5
1,611 posts
 
And how does one acquire an immunity to interconnect cables?  Is it from a consistent exposure to same that you build up a natural resistance to them?  Sheeeesh!🤔😝
More to discover