Thiel cs2.4 upgrade to cs 2.4 se


I'm currently using thiel cs2.4. Any master can advise on how to upgrade to cs2.4se by changing its capacity? May i know the value and specs of the capacitors? What is the sound difference between cs2.4 vs dc2.4se? Tq
desmond888
Hi guys, i intend to get claritycap csa 10 ohm + 3.9ohm to replace the original caps 13ohm +1ohm and claritycap csa 10ohm +18ohm to replace 27ohm + 1ohm original caps. Do i need to change or remove any resistors? Any opion on this combination? 
Hi guys, i intend to get claritycap csa 10 ohm + 3.9ohm to replace the original caps 13ohm +1ohm and claritycap csa 10ohm +18ohm to replace 27ohm + 1ohm original caps. Do i need to change or remove any resistors?
I think you mean 10uF+3.9uF and 10uF+18uF, that should be fine and you don't need to change any resistor unless you want to upgrade the resistors to higher quality.
desmond888

I look forward in seeing your presence over on the Thiel Owners thread. As luck will have it, the Gentlemen are working progressively on this very subject. Stay tuned.

Happy Listening!
desmond888

in particular - follow Beetlemania, Holco and TomThiel for answers to your initial query.  Happy Listening!
@desmond888

Your Clarity Cap plan sounds good. You can save money and space by going with the 250 V version for the larger capacitance value (ie, 10 and 18 uF) and 630 V version for the smaller value (3.9 and 10). Another path to 28 uF is to get 25 + 3. Madisound has the CSA 250 in 25 uF and I think Partsconnexion has the 630 V version of 3 uF. You might also get add a small bypass to each, say 0.1 uF. I’m going to try Multicap RTX at ~1% but Cornell-Dubilier is a worthy contender, among others.

You might also upgrade the 43 uF cap which is a subfeed. That cap is downstream from the 16 ohm resistor so you can go with a lower voltage. Until I started working with Tom Thiel, I considered a 39 uF ERSE Pulse X (100 V?) + 3.9 uF CSA250V. Finally, those 100 uF electrolytics should optimally be replaced with MPT-type capacitors. Again, ERSE PulseX is a worthy contender but you might have trouble fitting those on your boards. At the least, I suggest replacing the electrolytics with fresh ones (see Tom Thiel’s recent post on the Thiel Owner’s thread).

While you’re in there, I highly recommend replacing all resistors with Mills (or Vishay-Mills) MRA-12s. Sonic Craft has all the CS2.4 values although you have to mix and match the old (Mills) and new (Vishay-Mills). Only about $100 for all and makes a worthwhile improvement in SQ.