AV7704 Audyssey


Question.

I ran Audyssey the other day... and it claimed that some speakers were out of phase.  How could this be possible it all speaker wire terminations are matched correctly.

pos to red 
neg to black

What other reasons would the system claim things were out of phase?
lightfighter2018
jim is right, but also, if you have different types of speakers.

In multi-way speakers, designers will often flip a driver relative to others to achieve correct phase relationships. So if you are using mixed brands of speakers I could see this happening.

The absolute best way to tell is to use a battery. A standard AA will work, and is safe. Attach to each speaker, and test the direction the woofer moves in with the + of the battery attached to the + of the speaker.

You could probably also use a 9V if you need a little more oomph. :)

Best,
E
I do have different speakers as rear channels. Sonance in-ceiling speakers. B&W CDM9NTs for LR and matching CDMCNT for center ch.

Is this something I need to actually fix to get best audio performance?  If they truly are out of phase -- is this an engineering / assembly / design error?

-----

In doing the battery test - pos moves driver forward I assume?  Assuming this is correct... any movement forward would be considered valid phase?

For clarification as to steps in this confirmation test:

1. remove speaker wire from amp. 
2. connect speaker pos and neg to pos and neg of AAA or 9v battery.
3. observe direction of drivers.

Question... 

My L and R speakers are technically a four speaker system. NT tweeter, FST driver, and the two 6.5in drivers that actually move back and forth - in unison ( I believe )... if these drivers move in correct direction - can I assume my tweeter and FST driver are also in correct phase since I won't be able to observe them moving if at all?

I will also double check all speaker and amp connections to verify pos and neg are connected correctly.


Thanks for the information.


It’s likely that the midrange in your tower’s is intentislly Wired out of phase (for better time coincidence). Just skip the warning.  
  
Some Audyssey tips:  
 
1) The first mic position should be dead-center in the seating area, even if you have an even amount of seats (no center seat). All other positions should be no more than 3ft away, do not go around to the other seats in the living room, and it’s ok to have then at different heights (to simulate where your head will be at, such as sitting up and slouching). 
 
2) Dynamic EQ is awesome, but has limitations. It’s default offset, 0dB, is for movies, since tv and music is more dynamically compressed, choose the most appropriate setting for you (I use 5dB as I watch a lot of movies and music that has a RMS-to-Peak dynamic range of like 6dB, so not that dynamic). All this does is alter the frequency response  were on listening volume, as our hearing is not linear, look up the Equal Loudness Contours or the Fletcher Munson curves. 
 
3) Dynamic Volume should be turned off, it’s just dynamic range compression (night mode). So only really helpful if you live in an apartment or want use your system without waking up the house.