2. cables
  3. 141568-1009

Dealing with a power amp that need 20A connection

I just bought a used Audio Research power amp without knowing it needs 20A connection.
When I received the amp, there was no power cable included, and I've found out that the amp has a connection that I've never seen before. I thought it might be for 250 Volt, but later found out that this amp needs a special power cable with C19 type female connector and it has to be 12 AWG and 20A.
So, I ordered a 20A 12AWG power cable and a PS Audio power receptacle that supports 20A male connector type.
After reading a few more articles on 20A power amp, I may also need a 20A circuit breaker. The problem is, the circuit breaker for the audio room is 15A. Does it mean that I need a new breaker with 20A to use the amp?
What a hassle.
The seller did not mention anything about the cable power requirement and I assumed that it was included, but the seller didn't seem to have known anything about this amp. 
So, installing a new circuit breaker is something non tech people can do? If not, how much would I need to spend for professional job?
Would it be just OK to use 15A circuit breaker for the amp as long as I use 20A 12AWG power code and don't turn the volume much high?
Thx advance for your input.
128x128ihcho
elizabeth
6,726 posts
 
You can use your already installed 15 amp breaker... no problem.And NO you cannot just stick in a 20 amp breaker to replace the 15 amp breaker in the box! The wires in the wall must be a certain size to use a 20 amp breaker.                 
As others mentioned the IEC is just for more area to allow good transfer of AC power.           
For the state of the art stuff, yeah you would want  several 20 amp lines. For mere mortals, a 15 amp will suffice until you decide to upgrade some more..
fsonicsmith's avatar
fsonicsmith
334 posts
 
Folkfreak nailed it. Look at it in simple terms. If the amp drew more than 15 amps, it would trip the 15A circuit breaker in your electrical panel and further, ARC would likely mandate a 20A male plug and warn you to install a 20A line, 20A rated receptacle, and 20A breaker along with 10Ga Romex on a dedicated 20A line. 
Relax and enjoy your new amp. ARC has been designing their amps this way for quite some time now. It's admittedly kind of silly. I own a Ref 150 SE and love it. 
ihcho's avatar
ihcho OP
329 posts
 
So, I can just use an adapter, and everything is solved?
All the C19 female type power cord I found in Amazon seem to have either 15A male type plug with 14AWG, or 20A male type plug with 12 AWG.
The cable has to be 12 AWG (or higher, like 10 AWG), so I thought the only solution would be to use 20A plug cable, which means I need to have 20A power receptacle, which might require 20A circuit breaker.
It is a big relief that there are much simpler solutions.
I ordered a 20A/10AWG power cable with C19 female connector and 15A male connector. It will take a while to get it, but in the mean time, I can use an adapter with my existing 12AWG 15A power cable.

fsonicsmith,
If my 15A circuit breaker keeps breaking, then I would think about installing a dedicated 20A breaker for the amp. Until it happens, I would be careful about not cranking the amp’s volume so high.

Thanks much!
gs5556
769 posts
 
What is the mains fuse rating of the amp? If it is below 12 amps you can safely use a 15-amp circuit breaker, 12 ga wire and a standard 15-amp receptacle.  
Post removed 
More to discover