AC Power Question

jea48

I don't know if its NRTL tested or if it can be used in the US, Ive been living in Vietnam for 8 years now, I left the states 22 years ago and have no idea whats allowed or not allowed as far has electrical code.

The ebey link does not show the proper EE 2.6, ( I only see two internal wires)  all the EE 2.6 I have seen or purchased came with three internal wires, neg,pos, grnd.

I meant Romex, I think 10g solid is fine for digital gear but for analog 8g. solid made a noticeable improvement.

Just got my electrical inspection a few days ago. Inspector kept asking me why I put in 10 gage wire and an outlet that didnt cost 1.49

I put in a dedicated 20A line that feeds a P15 regenerator. With everything running I'm not even pulling 5A. 

I can't speak high enough about the monumental change the regenerator made to my system

Its amazing how this simple subject always gets bogged down in complexity and code and comments, usually from people who've never done and so don't know what they're talking about. I've actually had the standard normal house wiring, and then run a dedicated circuit, and then run an even better dedicated 240v to a step down transformer. Say again, I've actually done the wiring and listened and compared.

Your best cost option is to put everything on one single circuit, conservatively rated. i.e. use 20A even if you could get by code with 15. Do not run two circuits. If you do then put all your audio on one, all non-audio (record cleaner, lights, etc) on the other. As someone correctly noted it takes only a very tiny difference in ground potential to produce hum. Again, I know for a fact and from experience you can and will get hum when different components connected to different circuits are connected together. Different manufacturers follow different construction so that what looks the same is not. i.e. just because you see a ground plug does not mean the manufacturer connected those pins with a wire! So you may sometimes get away with it. Or you may just give yourself a headache.

One circuit. KISS. Capiche?

+1 @millercarbon 
I tried initially using two runs and ran into hum issues. Now I use one run of 8 gauge on a 20A breaker into a Hubbell L20R/L20P.

noromance1,688 posts01-28-2019 7:29am

+1 @millercarbon
I tried initially using two runs and ran into hum issues. Now I use one run of 8 gauge on a 20A breaker into a Hubbell L20R/L20P.

The problem could be with your equipment. Anything is possible.... Or it could have been the type of wiring and wiring method you used.

As for the use of multiple dedicated branch circuits to fed audio equipment, that is connected together by wire interconnects, it’s done all the time without any ground loop hum problems. Again when the type of wiring used, and the wiring method used for the installation of the branch circuits is done correctly. And that includes long branch circuit runs.


.