Esoteric A100 Service Nightmare


My Esoteric A100 which has been stuck in a safety circuit mode after an electrical surge.  I have contacted the Esoteric Service department and the unit was shipped to TAP electronics in Buena Park CA.  I was contacted by the service department that the A100s cannot be serviced in the US and must be shipped to Japan due to a required tool that is only available in Japan.  What???  I was quoted a shipping charge in the thousands $ and that there is no guarantee that the unit is even salvageable.  The interaction with TAP electronics was a nightmare but its not relevant here.   A100 has essentially become an expensive paper weight.  I am disappointed and puzzled by the lack of adequate service support for a unit that sold for over $18,000.  Any thoughts or recommendation on addressing this unit?  I am ready to consider the unit dead and move on.  This is unfortunately a last resort plea before I drop this unit to recycling.


Regards

Frank

kimf70
You might search for better shipping provider. I have sent the quite heavy and bulky SF Guarneri speakers, in their three large boxes to Hong Kong, from Europe, for 250eur, via Schenker fright company.

https://www.dbschenker.com/global

I am in no way associated with that company, just used their service
You could ask the guys on the Esoteric Forum @ AudioAficionado.com
One of the members  may have already gone through this.
Suggest you put in a claim with your Homeowner's Insurance company. Get docs to show unit is not repairable. If you have replacement cost coverage, you'll get the money you need to replace the unit.
Larry
Why not ship the 'tool' to the USA? Ridiculous situation.The company should be bending over backwards to help. I think what it is, is the DISTRIBUTOR chose the service provider, not the company. And whomever that is need to be taken to task for failing miserably.
"You could ask the guys on the Esoteric Forum @ AudioAficionado.com
One of the members may have already gone through this."

Actually it's .org, not .com.

I had to get a new drive put into my DV-50 and it was done in California. I've heard about the special "jig" that exists only in Japan.  Sorry to hear about your difficulties... good luck and let us know how it turns out!