Tube Rolling a Rogue Cronus Titan integrated amp


Hi this is my first post so please forgive any mistakes made thanks in advance.
I own a Cronus Titan integrated (Non Magnum version). I purchased this off E bay in the UK  where I live and to be honest it was a nightmare needless to say I had the Amp repaired by an extremely good Electronics engineer so didn't lose out too much financially.
The Amp was finally as it should have been :-)  and I have lived happily with it for the past 2 years, however( as always) the need to tinker has bitten me again so having read a few posts regarding said amp I have ordered a Matched Quad set of Gold Lion KT66's 

Now for the important bit 
I'm not technically minded especially with electrics what if any thing would I need to change on the amp to accommodate the valves as in biasing is usually set @ 35 on the meter( if that makes sense)

Sorry for the long-winded post and thanks for having me 
johnnylambo
nice  amp. have you considered contacting Rogue directly? I did and got a fairly prompt response from the owner.
Post removed 
Yes I'm considering that but it's Sunday and I'm just curious to see what people think or suggestions 
Received wisdom is that the preamp tube, the single one at the front (shared by both channels) makes the biggest difference.  Depending on what direction you want to go in, any of the usual suspects would be worthwhile: Mullard, Amperex, Brimar, Telefunken, etc.
  Talk with Rogue
they have fantastic customer support
the front end tube will make the most difference as @twoleftears. Has aptly pointed out 

also try listening to different output taps, that can make a dramatic difference and is free!!!