2. speakers
  3. 1325414932

Speaker Burn In?

Many components including speakers are said to require burn in of some period of time before they will reach their peak performance. Speakers like Magnepan are notorious for long burn in periods. Even cables are said to require burn in. Now I an faced with a set of speakers that need upwards of 240 hours burn in before they will 'open up' and play their best.

When faced with a required burn in how to yo do that burn it? Do you simply let it run it's course of time during your normal playback schedule or do you run the system 24/7 until the required time has been met? Are there other methods that can be used? Is their an accepted preferred method? And does the volume being played for burn in have an impact? Do higher volumes 'drive' the component harder and therefore provide a better burn in or to moderate or low volumes achieve the same goal?

In the past I have simply ignored the burn in as an effort and allowed the time to occur 'naturally' during my normal playback times. But with my last several components I have been more mindful of burn in and the recommended hours to optimum performance. Right now I am burning in a pair of speakers. I am about 40 hours in on non-stop playback. My normal listening level is from 72 to 81 on my system. When I leave the house or go to bed I drop the volume to 60 to 63. It is audible and in fact at this early time (3:40 AM) locally it even seems a little loud. How do you deal with this process?

Important process or waste of time thinking about it?
mwheelerk
tan43
128 posts
 
I have three pair of speakers that I swap out now and then. Each time I do I have to let them play for a few days before they sound right. To me speakers sound right when they completely disappear. All of these speakers have many hours of play on them. I also have two digital and one analog front end. When I switch from one to another they also have to play awhile, but only maybe an hour or so.
I guess everything has to burn in, but still need to warm up before you can judge them. I just turn on cable radio to let mine warm up.
polk432
1,116 posts
 
Xti16. The point I am trying to make is that you may not like the speakers after you take all that time to burn them in, and it may be too late to get a refund. Better safe than sorry. Linn Katans (sound good to me) take up to 600 hours to burn in? I ain't buyin' that.
tmsorosk
1,013 posts
 
Although most speakers require run in time to smooth out, there sonic signature will remain the same. So what you hear when new will still be there later.
magfan
1,583 posts
 
The capacitors may actually need more time to settle than any other part.

My panels had image shifts and cutouts for a couple hours...at decreasing frequency. By 20 hours the caps were formed and the speaker was 90% 'there'.

Don't worry about it. I'd suggest letting the new speakers cool periodically, too.
Play normally and you'll be ok.

600 hour burn in? Wacky. That's almost 7 months at 20 hours / week.

How much 'break in' time for the speakers is actually your EARS / brain adjusting?
st01
36 posts
 
I just bought a pair of B&w 802 Diamonds and a Classe 2300 to drive them. They sound great right out of the box after being delivered on a chilly morning. Letting them burn in with use, which is heavier during the holiday period.

The Sony 5400ES took a week to sound good and two weks of 24/7 burn in to sound its best. Same for the etymotic headphones i use with my ipod.

So it seems to depend on the units and i would not generalize.
More to discover