I want to re-introduce this subject.


I couldn't find it, so I will re-introduce this subject. Why is cd so volume dependent? This doesn't necessarily have to do with cd, as I'm interested in volume in general. Basically, I was attacked(or directed to) in the area of my preamp-which could have an effect. I just think, especially after understanding that many times there are many mikes involved, that what I have to say has some validity-no matter what my preamp is. Some of the questions I have have has to do with remote volume controls. Are they as accurate as the normal potentiometers? I say this because I changed the volume for a Jim Carrol cd, and it took me over a week to dial in the correct volume for most cd's-which is different than my volume for lp play. Come-on guys, this is too much work! Any help here would be appreciated.
mmakshak
Thanks for all the ideas/help given. I don't have a remote, so volume involves a little more. I guess that I'm satisified with one volume that plays most cd's okay. My lp setup requires a much higher volume than cd, also. Do remotes have the same or better resolution of volume that a volume control has? I did listen to an Audio Research Ref 3 with remote. The volume actually seemed to push the sound further away when it was lowered. Since volume is so critical to me or my system, I'm asking this question before I buy a new preamp.
A different preamp will not change the fact that all CDs are recorded at different levels. The result when playing your CDs will be the same.
This isn't a problem that can be corrected by adjusting your volume control.
'Hot' recordings (i.e. compressed) sound offensive at any level and one is forced to play them at low volume levels. With properly mastered recordings one can seemingly turn up the volume forever without being 'attacked' by the music.
I just purchased BUILT TO SPILL's "YOU IN REVERSE" on CD and it is so 'hot' that it is virtually unlistenable.
A double LP version is planned but I don't want to waste another $17 just to have this poorly mastered album in a different format. What are the chances that the record will be completely re-mastered for the vinyl release?
I'm not certain Mmakshak's volume issue has to do with hot recordings (overmodulated...especially in the upper mids). Perhaps he can clear this up. I do understand the issues of hot CDs (they are rare in my collection), and CDs released with volume levels different from disc to disc. These are separate problems...the latter not really being a problem, but rather a nuisance.
Digital recordings have a definite maximum signal...all sixteen (or 24) bits set. When the CD is mastered the engineer should set the input signal level so that the loudest moment of the recording is just below this "brick wall" maximum level. This will provide the best possible resolution. This is similar to the situation of mag tape recording, where the maximum level should be set just below saturation (clipping). However, even two CDs mastered in this way can sound very much different in overall loudness according to how much compression is applied.