Vandersteen 5A- Power Cords


Any Vandersteen 5A owners using audiophile power cords for the subwoofer amps? I know Richard recommends the stock cords.

I was considering the Audioquest NRG-10 cords which I believe will fit in between the heat sinks on the amplifiers.

Any input would be appreciated!

Thanks!

Tom
tnewell1
If one wants to experiment, buy some decent Furtech connectors,even the entry level CU ones will do.
Then take some # 12 romex solid core wires ,remove the un-coated ground wire and the plastic sheath.
Take an electric drill ,insert the black and white wires in the opening of the drill, tighten the wires.At the other end put the wires in a vice.
Start the drill and it will twist the white and black wires so that they look as good as what the big boys do.

Then take a plastic covered wire from the same bundle of romex that you've used and make the ground connection.Twist the ground by hand evenly spaced as possible around the outside of the twisted wires and go in the opposite direction.

Then attach the three wires to the proper recptacles and plug into something using such cords as a test,precaution, but really, it's not hard, just make sure all the connections are snug.

This makes a decent upgrade from a stock molded rubber power cord.

I've found the bass is deeper, tighter, there's less haze. The sound has more focus.

The only pit fall is that you should not try to bend it,it's not flexible!
If you need to go round corners or don't have linear runs from your power outlets to your gear forget about this experiment.

Also if you feel that this may void your insurance or that you won't be able to sleep at night because this isn't UA approved, forget about it.

But also remember that this is the same wire that is running hidden between your walls.

Is anybody losing sleep over that?
Actually after lots of trials I was able to make my own cables for my 5A's. The trick is to get the plugs to fit into the speaker side...between the fins of the amps. I got a Cardas connector (3455 IEC CONNECTOR). I chose these because it is very easy to remove the plastic surround exposing the 3 connectors. Make sure you wire it properly and insert the pins properly to the amp. Make sure also, that you use electrical tape to make the unit electrically safe. I use Neotech cable ...I wanted the diameter to fit the connector on the wall side..so it couldn't be too larg for the wall plug. To these ears, there is a definite improvement and no down side.
Regarding my post above...just remembered I had to sand down a piece of plastic to make it fit..not a big deal...the plastic is soft.